Offering Standard Helical Gearbox The Products:
Plastic Industry, at present, uses worm reduction gear boxes in extrusion and blow moulding plants, which creates many problems continous production works. Like oil leakage, over heating, noise, wear & tear of bronze worm wheel, etc.
1. Easy to assemble & dismantle.
2. Cost saving.
3. Power saving. (you may save up to 20 % power.)
4. Less requirement of space.
5. For bigger sizes water cooling is provided for better efficiency of gear box.
6. No maintenance required except periodic oil level checking.
7.Higher productivity compare to worm reducer.
GEAR BODY :
It is made of close grain cast iron, Which is absolutely dust proof & oil tight.
GEAR :
Gears are Helical type-made of case iron, hardened alloy steel, Gear teeth are hobbed and profile ground for smooth & silent running.
OIL SEALS :
Silicon oil seals are used to resist very high temperature resulting from the heaters on the barrel.
BEARINGS :
taper roller bearings of ample capacity are used to withstand thrust and radial loads.
LUBRICATION :
Lubrication is done by splash of oil, no separate care is required except periodic checking of oil level.
- Use proper grade of gear oil only.
- Change first filling of oil after two months of operation and then after every six months.
COOLING :
For 125 C.D & higher size, In addition to natural cooling, water cooling coil is given as standard fitment to imporve hea dissipation & efficiency. View Details & Send Response |  |
