Battery Power Supplier

Battery charger is a device used to put energy into a secondary cell or (rechargeable) battery by forcing an electric current through it. We provide Battery Charger 13.5V @ 2A. The salient features are enlisted below:

• Input: 90V to 265 VAC ; 50 Hz
• Output: 13.5 V @ 2A CV-CC
• Size: 146*70*30 mm
• Line and Load Regulation: <1 %
• Ripple < 1 %, Efficiency >70 % at full load and
normal I /P
• Operating Temperature: 0 to 50 deg C ; RH 95 % non condensing
• Input / Output Isolation > 1 KV rms @ 50 Hz for 1 minute. 

Other Features:

• Natural cooling
• Output short circuit protection
• Input emi - rfi filters along with MOV protection
• Screw type input / output connectors
• Output LED indication
• Integrated Mosfet and PWM controllers for greater reliability and space saving
• Output voltage can be adjusted over +_ 1 Volt
• Reverse polarity Protection.
• LED Indication after fully charged.
• O/P Current adjustment.

Power Supply cum Battery Charger for VHF Wireless Applications (Battery Charger 13.5 V @10A). The salient features are enlisted below:

• Input: 170 to 265 VAC ; 47 - 53 Hz
• Output: 13. 5 V @ 10 A to load
• Size: 160 X 75 or 13.5 v @ 5 A CV - CC for battery charging
• Line and Load Regulation: <1 %
• Ripple < 1 %, Efficiency >70 % at full load and normal I /P
• Operating Temperature: 0 to 50 deg C ; RH 95 % non condensing
• Input / Output Isolation > 1 KV rms @50 Hz for 1 minute.

 Other Features:

• Natural cooling
• Output short circuit protection
• Output over voltage shut down (latch type)
• Mains ON ; BATT LOW & BATT ON LED indication
• This battery charger is also available in open frame• Input EMI-RFI filters
• Screw type input / output connectors
• Battery reverse polority protection through fuse