Our nitrogen gas generators produces nitrogen gas from atmospheric air using PSA Technology. The system used by us is fully automatic and does not need any special operator for operation. Once it is started it generates Nitrogen at constant flow rate and at constant pressure. It has following features to its advantage:

• Environmental friendly
• Simple design
• Skid mounted units
• No hidden cost (only electrical power and cooling water needed for nitrogen generation.)

Some Advantages of using this equipment:

• Electronic Programmable Control Panel
• Automatic start and stop
• Highly reliable to run un-attended for months
• Very low maintenance cost
• Nitrogen gas supply always under your control
• Self-contained Skid Mounted Units for easy site installation
• Carbon Molecular Sieves life is minimum 10-12 years

Ammonia Cracker manufactured by us produces mixture of hydrogen and nitrogen which is commonly used in heat treatment furnaces. It is an electrically heated type furnace in rectangular shape which is made up of heat resistant material provided inside to hold the catalyst.

• Fully automatic, skid mounted units
• Hinged type door for easy inspection and maintenance
• Less Power consumption
• Low Skin temperature
• Very safe and proven design, No operator is required
• High turn down ratio

Our heatless drying unit has two towers filled with the desiccant for continuous drying operation. At a time, one tower is used for drying while the other tower is reactivated simultaneously. The capacities that we offer in this category are 10 NM3 / HR TO 1000 NM3 / HR. Some of the features that need to be highlighted are:

• High performance
• Low initial installation and operating cost.
• Almost Zero maintenance cost.
• Low temperature operation
• Reduced corrosion
• Only single phase electric power is required
• Desiccant life around 3 – 5 years.

Our Heat reactivated dryer are used when in needs of air at very low dew point. In our model desiccant is regenerated at higher temperature with little dry air purge. Due to dry air purge and thermal regeneration, residual moisture loading on desiccant becomes low and this gives low dew points. Capacities offered by us are 5 NM3 / HR TO 5000 NM3 / HR.

Features:

• Fully automated
• Low Purge air requirement
• Minimum Gas purge loss
• Longer utility life

In our heat of compression type dryers, hot air at 120 degree Celsius to 140 degree Celsius from compressor discharge is directly used for the desiccant regeneration. Running cost of this dryer is virtually NIL. This model has two drying towers filled with the activated alumina or molecular sieve desiccant and alternate in process every 4-hour automatically. Some of the important features are defined as follows:

• No Purge loss design
• Easy maintenance
• Fully automated
• Negligible operating cost

We design and manufacture different kinds of pressure vessels, air / gas receiver tanks and other purpose equipments for diverse industrial purposes. We carry out hydro-test of the vessels and then dry it quickly with the pneumatic air to prevent rusting. We also make red-oxides coats and colors based on customer requirements.

Our reliable and quality oxygen analyzers with special features like digital display, easy calibration, and long life sensors are portable and on-line gas analyzers that are used to monitor performance of gas generators. It is a sealed electrochemical fuel cell that generates signal in direct linear proportion to the oxygen concentration in the sample stream. It requires no periodic maintenance like replacing electrodes or electrolytes and can be easily calibrated.

These are very accurate, reliable, with very rapid response time and do not affected by change in fluid temperature or fluid flow rates. These can be carried anywhere easily and can be connected to nay device easily.