Arma Plast

PVC Dip Coating Plastisol, specially formulated for coating electroplating jigs, hand tools and other metal coating applications.

Application :

A typical cycle for hot dip coating is as follows :

•  Clean and degrease the metallic article.
•  Preheat the article in an over at 170 to 190⁰C for 7-12 min.
•  Dip the hot article in dip coating plastisol at the rate of 20cm/minutes.
•  After a dwell time of 30 seconds slowly withdrawn the article form the plastisol  bath at the rate of 10 to 12cm / minutes.
•  Allow excess dip coating plastisol to drain off.
•  Suspend the article in the oven and cure at 180 to 200⁰C for 20 to 30 minutes.

To obtain a thick coating, semigle the first coat at a lower temperature of 140 to 150⁰C for 5 to 10 minutes, and repeat the complete cycle (steps 4 to 6)

It should be noted that thickness of coating is controlled by degree of preheating and the duration the article remaining in the dip coating plastisol tank.

Uses : Dip Coating Plastisol used for coating metallic articles like electroplating jigs, wire baskets, dish drainers, racks, ducks, gratings, rods, handles etc.

Packing : 25 Kg and 50 Kg containers.

Storage : Dip Coating Plastisol have tendency to thicken ( Increase in viscosity ) on standing and therefore should be stored in a cool and dry place.

Shelf Life : Six months under normal temperature conditions.