All- Heating Mantles are individually constructed and factory inspected for the highest electrical standards. Each heating element is incorporated in woven fiberglass yarn and fitted into a spun aluminum housing, powder coated. All Heating Mantles are supplied with built-in on-off energy regulator.

Standard Heating Mantles are designed to take only one size of flask. Sizes are available to fit round bottom flasks from 100 ml to 20 Litres. The snug fit of the heating surface, which is in close contact with the glass flask, ensures good thermal efficiency.

Construction of these Heating Mantles are similar to standard Heating Mantles, ' but the housing is made of high quality stainless steel. All Heating Mantles are supplied with built-in on-off energy regulator.

These Heating Mantles are designed to take only one size of flask. Sizes are available to fit round bottom flasks from 100 ml to 1000 ml. The snug fit of the heating surface, which is in close contact with the glass flask, ensures good thermal efficiency.

To Heat a number of round bottom flasks simultaneously (for extractions, distillations, and digestions) Extraction units may be used.

All Extraction Mantles have individual energy regulator with indicator light for each heating surface, allowing liquids with different boiling points to be heated alongside each other. The robust construction permits continuous operation of the units as required by routine extraction tests.

Extraction Mantles are available in 2 models, 3 recess and 6 recess. The heating elements are housed in a strong Aluminum housing, powder coated in attractive colour.

'AVLAB' Test Sieves are available in spun brass frame or joint less stainless steel frame with stainless steel wire mesh or perforated plate in different aperture sizes from 125mm opening to 20 microns

Micro Test Sieves
Micro Test Sieves are available in. one piece brass frame of 3, 4 and 6 inch diameter with suitable Lid and Receiver.

Coarse and Fine Test Sieves
Coarse and Fine Test Sieves 8, 12 and 18 inch in diameter with Lid and Receiver assembly are also available.

Wet Washing Sieves :
For samples that need to be separated with the help of wet washing. Available in 8 inch diameter by 4 or 8 inch deep with brass frames. A complete range of aperture sizes are available.

Lids and Receivers
Lids and receiving pans are available in stainless steel or brass in 8 and 12 inch diameter

Very useful for heating test tubes, " crucibles, small flasks, beakers, etc. The heating element is spiraled Nichrome wire enclosed in refractory casing. Works on electricity.

These baths are double walled with high quality heavy guage stainless steel. The gap between the inner and outer walls insulated with fine quality glasswool. The bath is fitted with immersion heater. Temperature is controlled by a thermostat from ambient to 90 degC. The bath is provied with pilot lamps, concentric rings, power chord and drain plug.