Product Properties and benefits:
For wiping method, no need to dilute the product ultraclean-uls04.
Have to use it in 100% concentration.
For Dip or spray or by ultrasonic vibrating method etc adopt the following procedure
Concentration : 10 litres for every 100Ltrs of working volume.
Free Acidic points
(Strength) : 10 to 15
Operating temperature : ambient temperature
Duration of dip : Generally about 5-20 minutes. (Depending upon the
Fill up the tank with water to approximately three-fourth of the intended working volume, to this water, add s-l-o-w-l-y ULTRACLEAN – ULS4in the proportion of 10 liters for every 100ltrs working volume, while adding, stir the water to endure dissolution of the chemical; add further quantities of ULTRACLEAN –ULS4only after the first lot
has dissolved. When the required chemical has dissolved, add more water to makeup the working volume. The bath solution so make up should show a point age of 10 to 12.
(i) If the point is less than 10 to raise by 1 point, add 25 litres of ULTRACLEAN – ULS4 for every 1000 litres
Following Points To Be Kept To Discard The Tank Solution
Sometimes, the points (strength) level will be satisfactory but degreasing will be below par. With each load, a certain amount of oil is removed from the work pieces and retained. When this oil content reaches 3% discard the bath solution, no matter what the point age chemical strength is.
ULTRACLEAN – ULS4 is acidic in nature and clothing should be protected if there is any possibility of continuous or frequent splashing with the solution. Wash off any splashes on the skin at once with cold water. If the solution gets in the eyes, wash out with liberal quantities of water and obtain immediate medical attention.
Other Information :
Pay Mode Terms: L/C (Letter of Credit), T/T (Bank Transfer)
Port of Dispatch: chennai
Production Capacity: 500tonsperday