THINNER is a mixture of esters, glycol, alcohol,
aromatic solvents and ketones suitable diluents to
all nitro products. It is manufactured for reducing
lacquers before they are applied by different
1. Quickly reduces the consistency of the lacquer/paint
to the required degree.
2. Improves film smoothness of lacquers/paint when
applied either by spray or dipping thus
extending excellent finish.
3. Lacquer/paint dries without blushing, resin blush,
pinholing and other surface defects.
4. 4 . No “ orange peel” developed after the
evaporation of . Thinner, and therefore
increases the tensile strength of the film along
with its gloss
Appearance Colour Transparent
Specific Gravity ASTM D 3505 .85 + / - .02 Kg. / lit.
Colour (Saybolt) ASTM D 1209 +30
Initial Boiling Point ASTM D 850 56. 2
Copper Corrosion ASTM D 849 none
Non – Aromatics ASTM D 2360 50 – 60%
Flash Point (Abel) IP 170 100C
. THINNER has an average evaporation rate
suggested for all Nitro Products when application is
made in normal condition of temperature and
. THINNER has a certain action preventing milky
effect of the surface.
Keep the container tightly closed. Shelf life is
unlimited in close container. Keep away from direct
sunlight and other sources of heat or ignition; do not
smoke in storage areas.
Available in 500 ml.1 lit , 20lit (Pail) and 200 lit
THINNER contains highly flammable solvents.
Harmful if inhaled and if absorbed through skin can
cause irritation. Always use protective gloves and eye
goggles when handling this product. It is highly
recommended to provide proper ventilation on working
area. Keep out of reach of children. If contact with skin
or splash in eyes, wash with fresh water for a couple of
minutes while removing contaminated clothing and
shoes. If affected by inhalation of vapor, remove to
fresh air. If swallowed, call a physician immediately.
Do not induce vomiting