Axis Autogas

Model : AX-102 - It is a 3 position changeover switch for Gas/Petrol. Also manual push button switch to engine priming.

Model : AX-202 - For carburetor car. This switch has a pulse sensing mechanism, which cuts off the supply of gas, in case engine stall or fail to start within 2 sec.

Model : AX-201 - For MPFI Cars. This is a Micro Processor based switch, for MPFI Cars. Here the Car start on petrol & change over to gas on declaration automatically.

mechanical devices that by using the venturi principles, ensure correct air/fuel mixing in both static and dynamic conditions.

technical specification: max. Inlet pressure - 45 bar, ist stage adjustment pressure 0. 8 bar, power supply 12v.

apart from two stage reduction, it incorporate solenoid valve which interrupt the supply of gas to the mixing unit in passage from gas to petrol mode, in fuel injection vehicles.

it is a two stage pressure reducer, which reduces the pressure of gas in two stages, that allow stability at high as well as low pressures. The passage of lpg from liquid to the gas phase takes place by a drop in pressure and by absorption of the heat taken from the reduction unit, heated with the coolant of the engine cooling circuit. The design allow for better idling in cold and hot condition. It is equipped with priming coil, which is used for cold start of vehicle.

this device is positioned between the petrol pump and the carburetor which cuts off the flow of petrol during gas operations. It is equipped with a manual tap in case of failure of the electrical device.

Shut off Solenoid Valve is positioned between the tank and Regulator. It cuts off the flow of Gas during petrol operation or when the engine is switched off. It incorporate an interchangeable filter and magnet for any impurities that may be present in the LPG.

during gas operation, these devices cuts off the flow of petrol on cars equipped with electronic injection and emulate the signal of the injections of other sensors.
the right emulator model for each car varies depending on the type of injection system involved in the conversion.

quality lpg auto tanks from samcelik, turkey. These tank meet ecr-67-01 norms and also indian bis-14899 standards. There are two type of tanks - cylindrical& torroidal.
axis multi valves have been developed in compliance with ecr-67-01 norms. The features are:
excess flow control, manual service valve, lpg level gauge, 80% fill limiter, pressure relief valve.

this device is composed of an electronic commutator, a stepper motor and a flow actuator. It is designed to be fitted on catalytic vehicles.
it requires no manual adjustments and can automatically adapt to the different environmental conditions and use of the vehicle so as to ensure optimum carburation in terms of driving, consumption and emissions.