Bonjour Enterprises

By making use of qualitative raw material, we manufacture architectural coating. This gives an attractive look to the surfaces and never fades for a long time. We can provide our coating as per various industrial requirements. These are acclaimed for their features such as scrub and stain resistance, excellent color retention property and washable. Following are various types of paints offered by us:

 

• BPL Wall Neutralizing Cement Primer. (For Interior)
• BPL Premium Emulsion Paints. (For Interior All Shades)
• Super Acrylic Emulsion Paints. (For Exterior- All Shades)
• BPL Wall Neutralizing Cement Primer. (For Exterior)
• BPL Premium Acrylic Distemper (For Interior All Shades)
• only looking navi-mumbai&mumbai area.

We offer Epoxy coatings, which is our Epoxy Polyamide Cured Hi-Build Epoxy Finish. Our coatings is a two pack polyamide cured High Build epoxy coating, which specially prepared for use in painting storage tank exteriors exposed to humid, saline and chemical environment. The coating helps to resist crude and refined petroleum oils and it gives protection against chemical fumes and spillage of alkalies, salt, solvents or mild acid solutions. These coating are widely used in heavy duty systems for power plants, refineries & petrochemical units, gas plants, fertilizer plants, chemical plants, pulp & paper mills. The preparation for various surfaces is given below: 

STEEL SURFACES:

For this, surface should be completely clean and dry before applying primer. degrease and blast clean to Sa 2½ grade minimum of Swedish specification SIS - 05 - 5900 - 1967.If blast cleaning is not practical for the user, make full use of mechanical tools along with manual cleaning and wire brushing to eliminate loose rust/scale to St 2 or St 3 grade of Swedish specification.

CONCRETE SURFACES:

For new concrete surface, should be ensured that the surface is cured for minimum 2 months. Remove laitence, loose surface powder by light sand blasting. If blast cleaning is not feasible, roughen the surface by acid etching with 10% Hydrochloric Acid solution followed by thorough freshwater hosing to remove any residual acid. The surface should be perfectly dry and clean before applying primer.

For old concrete surface: Remove grease and oil by solvent wiping. Remove water-soluble contaminants by fresh water hosing. Roughen the surface by acid etching, if light sand blasting is not feasible. The surface should be absolutely dry and clean before applying primer.

APPLICATION DETAILS

Method of application:

Air less spray / Brush Airless spray essential for the required high film build and uniform finish

• Tip Range 21 - 26 thou.
• Notes on Airless Spray:
• Total output fluid pressure - 2500 - 3000 psi. (176 - 211 kg/sq.cm.)
• Pot life : 2 - 4 hours
• Thinner : SPL No.1
• only looking navi-mumbai&mumbai area.