Caretronics

Noise Suppressors and Indicators for AC/DC solenoid coils for hydraulic/pneumatic valves with plug-in connectors conforming to DIN 43650 types A & B.

Protects the CNC/PLC systems from noise during solenoid operation. Bright LED indication when solenoid is energized. No additional wiring or soldering required. Protects against high voltage transients in power supply. Improves relay contact life.

For troublefree operation of machines and control systems, the need to suppress harmful voltage surges - transients - produced when motors, contactors and other inductive loads are switched off, is well accepted.

CARETRONICS make contactor coil surge suppressors are available in varistor based, RC based and diode based types.

10 RC 22 - RC based suppressor for 24 volt AC/DC systems.

C 13014 - Varistor based for 110 volt contactor coils.

C 24014 - Varistor based for 220 volt contactor coils.

CS 503 - Diode based for 24 volt DC systems. DIN rail adaptors are available for all models.

Care Interface Modules provide easy interconnection from connector equipped multi core or flat cable to discrete wires. The compact module designed with terminal blocks is ideally suited for input/output interface between computer and control equipment. The unit snaps easily into 35 mm DIN rail.

Interface Modules suitable for flat cable connector, D sub connector or Euro connector are all available.

Automatic waterlevel controller capable of starting and stopping water pump at preset levels of water in both top and bottom water tanks.

Continuous water level indiacation -4 LEDs for each tank indicates water level.

Provision for both automatic and manual operation of water pump. In auto mode pump starts when water in top tank falls below a preset level and cuts off when water level reaches top set point. Pump will start only if water in bottom tank is above preset level and will cut off when bottom set point is reached.

The unit can be located anywhere in the house. Multicore cables (costing about Rs. 10 per metre) should be laid from each tank to the control unit. At the tank end the cables are connected to adjustable stainless steel stops mounted on a pvc pipe. The pipe with SS stops and plastic coated cast iron base are part pf the supply. However connecting cables to the tanks and wiring to the pump are not included in the supply. The unit can be plugged into a 3 pin 5 amp power outlet. A double pole ON/OFF switch controls power supply. The pump switch has AUTO, MANUAL and OFF positions. LEDs indicate "Power on" and "Power off" conditions.

This water level controller does not use float or other mechanical devices to sense water level and therefore has high reliability. With all these superior features we are offering this at a very reasonable price.