Creative Electronics

Creative expands its line of audio/video / RS232 / IR-over-CAT5 cable products with the introduction of a high-performance CAT5 Distribution Amplifier, Model CETx DA124. The DA124 is used to fan out to multiple locations the output from Creative CAT5 Transmitter Module, allowing the same signals to be sent to upto four different Creative CAT5 (Rx) Receivers. The RS232 or IR serial communication between the Tx and the four Rx’s provides the same commands to all locations.

Features

• Built-in lightning, power surge and transient protection.
• Distributes VGA, Stereo Audio, and RS232 or IR serial communications.
• Maximum RGB Resolution 2048 x 1536.
• One Bidirectional RS-232 or IR-link control path, three Tx only control path
• Uses easy to install, inexpensive CAT-5/5e/6/7/8.
• Selector Switch: For Analog adjustment. range up to 1000 Feet
• Data return selector— Selects which of the remote locations is able to send data back to the Tx unit.
• High ground loop immunity. For Better NOICE Reduction.
• Unit offers real—world Protection with Automatic Reset Fuses and built-in Power surge and transit Protection. This Unit also includes an isolated Power Supply for Protection against Ground Loops.

Creative introduces a high-performance CAT5 Tx1003 Transmitter and Rx1003 Receiver to be used in pairs for the extension of VGA, Stereo Audio, and IR or RS-232 data. The RGB-to-CAT5 Converter (Tx1003) converts the RGB video, Stereo Audio, and IR or RS-232 to signal levels that can be transmitted up to 300M to the remotely installed CAT5-to-Display Device (Rx1003) using AT5/CAT5e/CAT6/7/8 UTP cable.

Timing to correct the delay differences between the pairs : These are very cost effective, third-generation products which utilize application specific linear devices to provide the fastest video rise times and pixel cycling possible over UTP cable.

Signal Loops and Dual Outputs, : The Tx1003 features loop thru VGA and stereo audio inputs, while the Rx1003 provides dual VGA and stereo audio outputs. Eliminating need of Distribution amplifiers in many system configurations.

Features

• Adaptable Gain/EQ using a single control
• Bidirectional RS-232 or IR-link control paths
• Sync polarity preservation or conversion
• Line Level Audio inputs / outputs (-10dBv)
• Communication LEDs for reporting RS-232 or IR-link activity
• Duplex RS-232/IR + VGA + stereo audio over a single CAT5
• Dual Audio and Video outputs
• Uses easy to install, inexpensive CAT-5/5e/6/7/8
• Cable EQ / Gain range up to 1000 Feet
• Maximum RGB Resolution 2048 x 1536; Distance 1000 Feet
• Sends high-resolution UXGA, Stereo Audio and Compatible with Line Level Stereo Audio Signals.
• High ground loop immunity. For Better NOICE Reduction
• Built-in lightning, power surge and transient protection. Designated trimmer in the remote unit to compensate for cable length.
• Supports RS232 and IR.