Reciprocating air compressor spares are easily available with us.

• Cylinder
• Connecting Rod
• Piston Assembly
• Valve Flate
• Piston Ring
• Air Filter
• Gasket Set
• N.R.V. Assembly
• Bush
• Valve Discharge
• Valve Suction
• Oil Seal
• Oil Scrapper Set etc.

Screw air compressor spares are easily available with us.

• Air Oil Separator Kits
• Minimum Pressure Valve Kits
• Air Filter Element
• Unloader Valve Kits
• Oil Filter
• Oil Stop Valve Kits
• Check Valve Kits
• Blow Down Valve Kits
• Air Hose & Fittings
• Solenoid Valve Kit
• Lube Oil etc.

Refrigerated air compressor spares are easily available with us.

• Main Bearing Seal
• Valve Inlet
• Valve Outlet
• Carbon Seal
• Compression Ring
• Shaft Seal Assembly
• Center Bearing
• Gasket Set
• Crank Shaft Assembly
• Cylinder Sleeve
• Tyre
• Piston Assembly, etc.

Gas air compressor spares are easily available with us.

• Piston Ring
• Piston Assembly
• Cap Screw
• Teflon Ring
• Gasket Set
• Teflon Guide
• Auxiliary Valve
• Wearing Ring
• Discharge Valve Complet
• Suction Valve Complet
• Bushing Crank Pin
• Crank Shaft,etc..

Single stage air compressors are required for low pressure compressed air (compressed air pressure required up-to 100 PSIG).These are used in powder coating, chemicals, dyes and intermediates industries.



For Technical Specification click here the image

Two stage heavy duty industrial air compressors are used where the pressure requirement is more then 7kg / cm2 & up to 14kg/ cm2. These types of compressors are specially used in textile, plastic industries, garages, petrol pumps, blowering, pneumatic operations, etc.



For Technical Specification click here the image

Air-End Service
We care for your screw compressor air ends.

Air ends of screw compressors in industrial applications are exposed to heavy operation and thus underlie permanent wear. The Deep Pneumatics is specialised in air ends service to make the compressors run reliable again.

We offer

- Reconditioning and overhaul of all air ends independent from manufacturer.
- Reconditioning and overhaul of oil-injected screw compressor air ends.
- Reconditioning and overhaul of screw compressors in special applications.
- Fast and flexible order processing - from order intake to dispatch back to the customer.
- Turn-key service from compressor dismounting to start-up of overhauled compressor.
- Full documentation of all Reconditioning activities.

Air Receiver from 100 liters to 5000 liters capacity with working pressure of 7 kg/cm2 to 40 kg/cm2 are available with us.

By incorporating an Air Dryer in the compressed air system, the moisture count can be brought down to less than 80ppm which means very dry air. Dry air is an essential element of any pneumatic system, hence whenever compressed air systems are to be installed. An Air Dryer should be an integral part of that installation. Heatless or Refrigerated Type Dryer of 10cfm. to 2000cfm. are available with us.