We manufacture power distribution boards that not only save installation costs but also cost of equipment storage, handling and field testing. Following are the features & application of our product:

Features :-

1. Degree of Protection :-IP-52 to IP-65.
   
2. Painting: - Powder Coating / Spray Paint / Epoxy Paint.
   
3. Compartmentalized design eliminates risk to maintenance personal.
   
4. Sufficient space for incoming and outgoing cables.
   
5. Provided with buzzer & hooter during emergency.
   
6. Separate Bus bar and cable chambers.
   
7. Power Distribution Board shall have hinged door with lockable arrangement
   
8. Available with Aluninium / copper bus bar.
   
9. Fabricated with 2/2.5/3mm CRCA sheet steel.
   
10. Power Distribution Board is suitable for use on 415V, 3Phase, 4 wire, 50Hz, AC supply system.
    
11. Available in Cubicle and Pedestal type.
    

Application :-
These are widely used for :-

1. Protection against electrical Short Circuit, overload and earth fault of the system.
   
2. Control & monitoring of the entire electrical system of an industry / plant.
   
3. Systematic power catering to various load of an electrical system.
   
4. Normally used in Hospitals, Multi-storied buildings, steel industries, cement industry, open –cast mines, shopping mall etc.