Oxygen Plants / Nitrogen
Plants |
 |
Acetylene Plants |
|
|
Special features of Oxygen gas
plants / Nitrogen gas plants
- Our plants incorporate design features which enable our plants to
produce high quality nitrogen gas simultaneously with oxygen gas
production. This results in higher economical viability.
- Our plants are equipped with a highly efficient expansion engine,
which helps rapid and adequate cooling. On account of this our plant
operations exceedingly stable with a consistency in gas purity.
- High standard of purity of gases.
- Low power consumption, as our plant design is low-pressure cycle
of 30-40 kg/cm2.
- A special bypass valve is provided for quick production and
better cooling. (R-4)
- Automatic temperature indicating system-electronic scanner.
- International class pressure differential gauges are used for
liquid level indicators with stainless steel control panel.
- High quality insulation by Perlite power to prevent cold loss.
- liquid nitrogen withdrawal facility (Optional).
- Single pump for filling oxygen as well as nitrogen (Optional) a
Separate nitrogen pump (Optional).
- Heavy duty & reliable Ingersol Rand Worldwide air compressor
(4 stage) suitable to operate with the power .supplied by a diesel
generating set or normal power supply of 415/440 V-50 cycle (60
cycle optional).
- Raw material is only atmospheric air.
|
|
Special features of our Acetylene
Gas Plants
- No bulky gas holder required.
- No gas loss and high yield.
- Very simple and safe to operate.
- Low power consumption.
- Low maintenance cost.
- Automatic controls for feeding water, maintaining temperatures,
pressures, and slurry drain are reliable, efficient and are of
international standard.
- Excellent absorption of gas in cylinders.
- Manufactured as per Designs and Drawings meeting international
standards.
- Manufactured under ISI quality marking & BS Standards.
- No fuel is required.
- High Purity is achievable.
- Low capital & running cost.
- Fully automatic.
|
Oxygen / Nitrogen
Air Seperation Unit
Model: ORG100 |
Process
description of Acetylene Generator
The Acetylene Generator of the organisation is of an advanced design,
incorporating several features not ordinarily found in other generators.
Pneumatically controlled valves and highly sensitive sensors, integral with
the temperature control instruments, perform all operations. These in turn
open the water inlet valve or residue drain valve etc. Two hydraulic pumps
help to open and close the supply of calcium carbide, which is fed into the
generator by screwed conveyors. The screw feed mechanism and the agitators
are operated by flameproof motors and fittings. The entire operation is
perfectly synchronized to give maximum efficiency and simplicity in
operation. An failure, whether it is of power supply, water or air is
signaled visually and also audibly when an alarm bell rings to alert the
operator.
Only flame proof lights & electrical fittings according to IS2148-68
(group II) or BSS-229 may be used in an acetylene plant building. Acetylene
cylinders must be of specification IS: 7312:1974 or ICC:8.
