Golden Electronic Controls India Pvt. Ltd.

Our oil cooled stabilizers (three phase servo) that we manufacture are considered reliable due to its digital and controlling with micro controller. These oil cooled stabilizers are manufactured using qualitative raw material. The material is inspected as per internal components manual. All the Individual assemblies are tested on full load at 55 degree Celsius in oven for 48 hours to minimize failure. The final equipment is tested for accelerated life test to identify and replace any weak links. Some of the salient features of our Golden servo stabilizer three phase (oil cooled) are :

• Rugged and smooth as motor drive control through optoisolator circuit which is highly reliable


• Less active component avoids failure ratings Special electronic circuit to operate on gensets


• No effect of power factor and frequency variations


• Single PCB for three phase sensing and correction


• Automatic precision trip range settings at site without preset adjustment


• Voltage speed high torque dc servo motor proportionally controls corrections

 
Protections :

• High voltage protections


• Low voltage protections


• Phase rotation/single phasing preventer


• Input protection using HRC fuse


• Panel Control


• Control circuit protection using fast blow fuse

VAF / VF 3 Phase Model Start, Select, Stop / Reset
Panel Indications
VAF 3 PH model: Input On, Output On, Input High, Input Low, Phase rotation fault, over load, cutoff

Our single phase stabilizers (air cooled srvo) that we manufacture are considered reliable due to its digital and controlling with micro controller. These single phase stabilizers are manufactured using qualitative raw material and are sourced from reputed vendors. All the components conform to IS / BS / VDU standards. All the material is inspected as per internal components manual. Individual assemblies tested on full load at 55 degree Celsius in oven for 48 hours to minimize failure and the final equipment is tested for accelerated life test to identify and replace any weak links.
 
Some of the salient features of our finished single phase stabilizers are as following :

• High Reliability


• High efficiency


• Wide input voltage range


• Fast response


• Audible alarm for trip conditions


• Built in digital volt/frequency meter

Protections :

• Low voltage protections


• High voltage protections


• Phase rotation/single phasing preventer


• Input protection using HRC fuse


• Control circuit protection using fast blow fuse


• Panel Control

VA 1 PH Model : Select

Panel Indications
VA 1 PH model: Input On, Output On, Input Low, Input High, Over Load Cut-off

We manufacture three phase stabilizers (air cooled servo) that are equipped with digital micro controller. These three phase stabilizers are manufactured using qualitative raw material which is sourced from reputed vendors. The material is inspected as per internal components manual. Individual assemblies are tested on full load at 55 degree Celsius in oven for 48 hours to minimize failure and the final equipment is tested for accelerated life test to identify and replace any weak links. All such measures enable us offer products which conform to IS / BS / VDU standard.
 
Some of the salient features of these stabilizers are :

• 99.99% failure proof control circuit


• Built in digital volt/frequency meter


• No over under, shoots and hunting


• Built in bypass switch up to 100 KVA


• Sensing circuit is isolated from the mains

 
Protections :

• High voltage protections


• Low voltage protections


• Phase rotation/single phasing preventer


• Input protection using HRC fuse


• Control circuit protection using fast blow fuse


• Panel Control

 
VAF / VF 3 Phase Model Start, Select, Stop / Reset
Panel Indications 
VAF 3 PH model: Input On, Output On, Input High, Input Low, Phase rotation fault, over load, cutoff