Helisert Tools

NAG FASTMAN Extracting Tools

We are one of the leading manufacturers and suppliers of Extracting Tools. These products are installed too deep, cross-threaded or otherwise improperly inserted. Our product range is manufactured from high grade raw material that is procured from some of the trusted vendors of the industry. Clients can avail these products at reasonable prices.

For extraction, follow the simple steps below –

• Place the blade of the extracting tool on the top coil of the insert
• Hit the top of the tool with a hammer, causing the blade to bite into the insert
• Push down on the tool and rotate counter-clockwise to back the insert out of the hole

Manual Tang Break Tools

We are counted amongst the foremost manufacturers and suppliers of Tang Break off Tools. Our product range can easily be accomplished by placing the punch of the Tang Break-off Tool into the installed insert and resting tool squarely on the insert tang. Further, by striking the top of the tool with a hammer, using a sharp blow breaks off the tang.

Semi-Automatic Tang Break Tools

• Tool has a spring loaded sleeve which actuates the punch causing it to strike a uniform blow against the tang in the assembled insert.
• Operation of this tool is single handed (as against manual tang break-off tool requiring both hands) and excludes the use of a hammer
• Suitable for inserts ranging from M2 to M10 or equivalent inch sizes

We are engaged in offering our clients a wide array of Inserting Tools. Our product range is manufactured from high grade raw material that is sourced from some of the reliable vendors of the industry. These products are valued for their high quality standards, dependable performance and high accuracy.

Technical specifications:

• Inserting Tools are used for FASTMAN Screw Thread Insert installation. These inserting tools are suitable for both Standard (free running) and Screw Lock Inserts.
• To use FASTMAN Prewinder Type Inserting Tool, retract mandrel and place insert in chamber with tang end towards threaded tip.
• Advance the mandrel until slot fully engages the insert tang. Rotate and advance the mandrel until the mandrel protrudes 1 mm from the tip.
• Hold tool firmly and squarely against work and install insert into tapped hole by rotating mandrel at a slow, uniform rate, until the top coil of the insert is 1/4 to 1/2 turn below top surface of hole