We offer the high precision and reliable Gas analysers which analyses the mixture of gases. We provide our clients a large series of gas analysers which are as follows :

Ø TCD BINARY GAS ANALYSER / GAS PURITY ANALYSER
Ø Oxygen Meter - % level OMPC (0.1% resolution
Ø Oxygen Meter - PPM level OMPM (1 ppm resolution)
Ø Oxygen Meter - Portable PPM
Ø Oxygen Meter - % Portable (Handled)
Ø Toxic Gas - ppm level Portable (handheld)
Ø Dew Point Meter : Measures moisture in air or gas samples, Range - 20°C to -100°C, Dew point.
Ø CO2 in fluegas analyser for boiler fuel efficiency : The method of measurement used is that of Katherometer. Sampling system - Water Aspirator or Suction Pump.

The Ultra High Pure Gas Analyser available with us is provided by Orthodyne - Belgium which offers various custom-built devices to meet clients specific analysis needs. The product is tailor-made as per the demands of end users. It uses the science of chromatography to measure impurities in virtually all gases. Some of the application areas of the product are as follows:

Ø Aerospace industry, for products’ high-precision and reliable measuring capacities
Ø Gas industry; in all facilities from air separation plants to gas bottling centre
Ø Steel making; to measure purity of oxygen.

Gases to be analysed	Impurities Detected
	H2	O2	N2	CH4	CO	CO2	Ne	Ar	Kr	Xe	CnHm
Hydrogen		Y	Y	Y	Y	Y	Y	Y	Y	Y	Y
Oxygen	Y		Y	Y	Y	Y	Y	Y	Y	Y	Y
Nitrogen	Y	Y		Y	Y	Y	Y	Y	Y	Y	Y

Figure: Few top analytical possibilities using Orthodyne chromatographs

In addition to the above gases, the product is capable to analyse following gases :
Ø Nitrous Oxide
Ø CF4 / R14
Ø C2F6 / R116
Ø Arsine
Ø Boron Trifluoride
Ø Boron Trichloride
Ø SF6
Ø CHF3 / R23
Ø Monosilane
Ø Phosphine
Ø Chlorine
Ø Nitrogen Trifluoride

Clarity, Clarity EA and Clarity Offline softwares provide variety of tools supporting the GxP practices. These tools enable to configure the chromatography station in a way to comply with the requirements of the 21 CFR Part 11 directive of the FDA. This ensures its suitability for use in regulated environments.
Clarity Lite does not contain some these tools and so it is not recommneded for use in regulated environments.

Supporting tools for 21 CFR Part 11 requirements

• Software Validation : Certificate of Software Validation is available upon request.
• Installation Qualification : The Test IQ (Installation Qualification) is an integral component of the station. This test monitors that the software has been properly installed and the results can be accessed from a printed protocol.
• Operational Qualification : Validator for OQ (Operational Qualification) is an optional package available for testing and validating the station. This is accomplished simply with the use of our chromatogram generator and a software utility.
• Logon with Password
• User Accounts : Selectable rights, unique user profiles This system allows to create a unique password protected profile for each user. The user profile then defines in detail the user's rights within the station (e.g. authority to effect changes in the methods of measurement) and may limit ones access to only certain connected instruments.
• Password expiration and minimal length
• Record of all changes : History of all methods and calibrations as part chromatogram files.
• System Suitability Test : Method performance and system consistency monitoring.

We offer the high precision and reliable Dew point meter /Moisture meter. It is used to measure the amount of moisture in air or gas samples, within the range of +20oC to -110oC dew point i.e. 23,000 ppm down to nearly 1 ppm. The product is basically a product of Shaw Moisture Sensors that has 1000 times’ dry capacitance as compared to other similar products. It requires only the room air for unique Automatic Calibration, which is done in seconds by our clients.

The product detects moisture in almost every non-toxic gas such as Argon, CO2, He, H2, Natural Gas, O2, SF6, N2 and Air. However, it is not suitable for toxic gases.

Applications :
ØWelding
ØLiquefaction
ØNatural Gas Drying
ØElectrolytic & Power Generation
ØAircraft & Medical use
ØInsulating Gas
ØTransporting Air
ØExplosives Testing
ØAir Dryers
Different ranges available with us are:

Shaw Gold Filter High Capacitance
Moisture Sensors with 20 year life
Purple Spot	-100/0 degrees c. dew point. 0/6000 p.p.m.
Silver Spot	-100/-20 degrees. c. dew point.
Red Spot DP	-80/-20 degrees c. dew point. For SADPR
Grey Spot Auto	-80/0 degrees c. dew point
Blue Spot	-80/20 degrees c dew point.

The moisture meters possess following attributes :
ØAffordable Price
Ø20 years sensor life
ØPrecisely Calibrated
ØClass 1 Quality Control ISO 9002
Ø4-20 mA. output
ØBoth Wet & Dry Alarm
ØOne Calibration for different gases
ØFast moisture sensor, one second response from dry to wet
ØAutomatic Dry down and easy user Calibration check with room air by the user himself.

We provide high caliber Gas Chromatographs to our esteemed clients. It has the power requirements of 230 VAC +/- 10%; 1.6 KW; 50 Hz. The product consists of main four parts as mentioned below:

Ø Main Frame
Ø Column Oven
Ø Dual Injection Port
Ø Pneumatic Control System

Its micro-processor based unit consists of following :
Ø Temperature controller for Injector, Detectors, Oven & Auxiliary
Ø Six step temperature programmer for oven, method storage capacity - min
Ø Ten method files (protected against power failure)
Ø Dust proof membrane
Ø Key-board and many other facilities

Salient features :
Ø Compact in dimensions & light weight because of special aluminum extrusion cabinet
Ø Low power requirement because of optimum oven design with minimum temperature gradient along column length
Ø Easy for servicing & upgrading because of modular design
Ø Minimum failure rate because of rigid construction.

The Hemaki Model - OM WMSP 100 Online Flue Gas Analyser is specifically designed for use on flue gases from combustion process burning clean gaseous flues. Alternatively, it can measure sample gases from oil or coal fired processes with additional heated sample filter.
Sample gas is drawn into the analyzer from the sampling probe or heated filter through a water or air cooled condensor by the built in sampling pump. any liquid formed in the condensor falls into the condensate trap. Next, the sample gas is filtered again then flows through a 5 way calibration gas valve, flow meter than onto gas detectors.

Measuring Range	O2 : 0-100%, 0-19.99% CO : 0-2000ppm, 0-4000ppm CO2 : 0-80% NO2 : 0-200ppm NO : 0-5000ppm, 0-1000ppm Temperature : 0-1200 deg C
Sensor Type	Electrochemical (Imported) CO2 : NDIR Detector
Accuracy	+-1% Full scale
Operating Temperature	0 - 45 deg. C
Sensor's Response Time	90% in less than 25 seconds (From low to high)
Output Linearity	Linear
Display	Dual line LCD
Power Source	230 volt Ac./ as required
Output	4 to 20mA & adjustible single alarm
Calibration	Calibration check with room air or By calibration gas (Recommended for better accuracy)
Cabinet	Analyzer with built-in suction pump mounted in wall-mount cabinet with Glass window

We provide elegant bird ringer wall clock that chimes with birds songs every hour. The product is capable to add life to your living room and produce a tranquil environment. It is specially designed by a proficient team of bird watchers. The songs are recorded from the birds in wild. We take utmost care to reproduce the quality & fidelity of songs.

Few of the features of the product include :
Ø Each song duration is 20 seconds
Ø Its dial is different from conventional clock dial
Ø There are various pictures of birds instead of the hour numbers such as Peacock, Fantail, Fowl, Malabar Whistling Trush, Koel, Jungle, etc
Ø The particular bird song will sound according to the bird picture at that particular hour
Ø It has an electronic micro controller with light sensor. This enables the clock to be kept in sleep mode during night and save on the battery during songs.

We provide the best quality Gas Purity Analyser/Binnary Gas Analyzer to our clients spread all over the world. Applications of the product includes following:

Ø Binary gas Analyser for on-line indication for gas mixtures such as Ar/N2, Ar/He, Ar/H2, Ar/Co2 and any other combination of two different gases.
Ø On-line gas purity/total impurity analyser with resolution 0.1% (for Hydrogen & Helium0.01%).

Features :
Ø Four Filament TCD (impoted) Diffusion type
Ø Change over value for sample and reference
Ø Two needle valves & rota meter for Gas Flow Controls

The prominent attributes of incorporated Electronic Control Panel are as follows :
Ø Digital Display 31/2 LED with 0.1% resolution
Ø Zero & Span (or two point) control for calibration to get direct read out of % selection
Ø Switch for % or mA current indication
Ø Filement temp control with overload protection saves filements
Ø Current is adjusted automatically as per composition gas
Ø Recorder out put -mv as standard

Optional Components/Settings :
Ø 4 to 20mA output
Ø Alarm Setting - Single / dual
Ø Cabinet - table mount or panel mount or wall mount
Ø Detector with flow through design is also available for fast response.

We carry an extensive range of various oxygen meters. The product is specially designed for accurate & reliable measurement of Oxygen in Air, Hydrogen, Nitrogen, Argon etc. It is based on Galvanic Oxygen Sensors to impart fast response. Few of its salient features are as follows:

Ø No periodic maintenance required
Ø Digital LED display
Ø Highly Reliable

Common Application Areas :
Ø Gas purity check
Ø Oxygen Plant
Ø Gas separation Plant
Ø Cylinder filing
Ø Inert Gas Purging

The range of oxygen meters available with us include :
Ø Oxygen Meter - % level OMPC (0.1% resolution)
Ø Oxygen Meter - % Portable (Handled)
Ø Oxygen Meter - PPM level OMPM (1 ppm resolution)

The domain of oxygen meters is offered by us in various specifications and each product has its own unique features, application areas and specifications.

We provide our clients with most precision and reliable toxic gas analyzer. The product finds applications in following fields :

Ø Bio Technology
Ø Combustion Efficiency Studies
Ø Human Occupancy & Safety
Ø Food and Beverages packing
Ø Pollution Monitoring
Ø Research & Development

Salient features of Toxic Gas Analyser :
Ø Easy to read Display / Fast Response
Ø Hand held Instrument
Ø Small & Light Weight
Ø Low Battery Indicator
Ø Audible / Visual Alarm (optional)
Ø Sensor, disposable Electo Chemical

GASES	RANGE	RESOLUTION
CO	0 - 500 ppm	1 ppm
H2S	0 - 100 ppm	0.1 ppm
SO2	0 - 20 ppm	0.1 ppm
NO	0 - 200 ppm	0.5 ppm
NO2	0 - 20 ppm	0.1 ppm
CI2	0 - 10 ppm	0.1 ppm
H2	0 - 1000ppm	0.2 ppm
HCN	0 - 100 ppm	0.5 ppm
NH3	0 - 50 ppm	0.5 ppm
O3	0 - 2 ppm	20 ppm
C2H40	0 - 20 ppm	0.1 ppm
PH3	0-5 ppm	0.05 ppm

We provide our clients with most precision and reliable Binary gas analyzer. The product finds applications in following ways :

Ø Binary gas Analyser for on-line indication for gas mixtures likeAr/N2,Ar/He,Ar/H2,Ar/Co2 and any other combination of two different gases.
Ø On-line gas purity/total impurity analyser with resolution 0.1% (for Hydrogen & Helium0.01%)


Features :
Ø Four Filament TCD (impoted) Diffusion type.
Ø Change over value for sample and reference.
Ø Two needle valves and rota meter for Gas Flow Controls.

Electronic Control Panel :
Ø Digital Display 31/2 LED with 0.1% resolution
Ø Zero & Span (or two point) control for calibration to get direct read out of % selection
Ø Switch for % or mA current indication.
Ø Filament temp control with overload protection saves filements.
Ø Current is adjusted automatically as per composition gas.
Ø Recorder out put -mv as standard.

Optional :
Ø 4 to 20mA output.
Ø Alarm Setting - Single / dual
Ø Cabinet - table mount or panel mount or wall mount
Ø Detector with flow through design is also available for fast response.

We provide the best quality H₂ Purity Analyser to our clients spread all over the world for purity testing of Hydrogen gas.

Features :
Ø One analyzer monitors all 3 gases for purity or purging: 0-100% Hydrogen in air, 0-100% hydrogen in CO2, 0-100% Air in CO2
Ø Digital readout
Ø Explosionproof gas detector cabinet
Ø 4-20ma output for 85-100% H2
Ø Fast response
Ø Very stable
Ø Detector cannot burn out even with no sample flow
Ø 2 levels of low H2 purity alarm
Ø Detector failure alarm


Hydrogen Purity Analyzer is designed specifically for monitoring hydrogen purity in the hydrogen feed to a power generator and to monitor the purging procedure during generator shut down.