Home » Our Products » Marine Lantern Accessories

Marine Lantern Accessories

We are engaged in Manufacturing a wide range of Marine Lantern Accessories.

Marine Light accessories are follows:

Flasher to give rythmic flash characteristic as per requirement
Lamp Changer : in case of Tungsten lamp or Hologen Lamp the lamp life is 1000 burning hours so to give un-intrupted operation, Lamp Changer is used to automatically change the position of fused or damaged lamp and bring the fresh lamp in focus of the lens.
Solar Panel : to charge the battery from solar energy we design the system of charging from solar panels with proper protection against over charging, complete discharge of battery and reverse flow of current etc.
Mains operation system : in case of Jetty lights, shore beacons or leading lights lights can also be operated from mains 230VAC. We design the un-intruped mains operation system up to 12VDC, 500Watt to run these lights.

Electronic Flasher

Item Code: EF-60

The advanced EF-60 Electronic Flasher is a microprocessor based unit. It has been programmed to give any one of the 256 characters/functions and simultaneously control day/night operation with internal or external Photocell & control the output voltage to the lamp. It can operate Tungsten or Halogen lamps and INA Lamp changer NLC-6. The Pulse regulated output voltage can be set to any value between 12V to 24V.

Specifications

Body	Aluminium Alloy
Input Voltage	12 to 28 VDC or 24 to 28 VDC
Output Voltage	12 V or 24V +/- 2%
Flash Character	Any Character from 256 characters approved IALA recommendations can achieved
Day Light control	By Photocell
Protection	Protected against short circuit and reverse polarity connection
Terminals	Brass Gold Plated
Fixing	Two M6 studs on 58mm centres
Weight	500 Grms approx.
Dimensions	100 mm Dia x 70mm Height
Lamp	12 Volt 10 to 70 W or 24 Volt 10 to 150 W

Send Enquiry

Lamp Changer

Item Code: NLC-6

The Lamp Changer is operated with all INA EF-60, EF-100, EF-150 Electronic Flasher. The turret can be fitted with 6 tungsten or halogen lamps and it brings the good lamp in focus automatically irrespective of its position. When all the Lamps are consumed, the turret stops after re-checking few times to save power. After replacing the lamps The lamp changer start working from any position of the turret automatically without resetting.

Specifications

Body	Stainless Steel IS 316 and PPCP Material
Input Voltage	12 Volts to 28 VDS
Lamp Contacts	Brass Gold Plated
Lamp Position	6 automatically selected position
Lamps	12 Volts 10 W to 70 W or 24 V 10 to 150 W (tungsten or hologen)
Supply cut-off	The Power is Cut of automatically on failure of all the 6 lamps to save power
Focal Height	150 mm
Fixing	Four Hole 6 mm dia at 76mx16mm centers
Weight	700 grms approx.
Dimensions	Height 165 mm x 155 mm x depth 150 mm

Send Enquiry