About UsWe specialise in torque measurement, and offer one of the biggest ranges of torque transducer in the world. We are also one of the few companies prepared to make special torque sensors, torque meters and load cells.
We have our own torque calibration facility and can also calibrate torque equipment by other manufacturers up to 28,000Nm.
If you are in Aerospace, Automotive, Marine, Offshore, Power Generation, Steel, in fact any industry involving rotating machinery, these are the pages for you..
|
Product ApplicationProduct Application Aerospace IML sold its first torque transducer to this industry in 1984 and has continued to assist with product development ever since. IML's first 25,000 rpm torque transducer was made for space shuttle fuel pump development in 1989.
Two non-standard transducers for this industry are shown here.
The upper picture shows a clamp-on torque transducer for wing flap actuator development and the lower one, a semi-special splined transducer made for an aircraft manufacturer in Holland.
Automotive 20% of IML sales are to the Automotive Industry. Our first `motorsport` drive shaft torque measuring system was supplied in 1996. Numerous test rigs and test rig transducers have also been supplied.
IML replaced the centre section of this (and other vehicle flywheels) with a strain-gauged arrangement to measure ‘real’ crankshaft torque.
This is one of three production test rigs for rebuilt commercial vehicle clutches measuring diaphragm load and displacement.
Marine Operators realise that increasing demands for close monitoring of a ship’s performance and running costs requires accurate and reliable measurement of torque at the propeller shaft. Torque measurement is used as an engineering tool to measure power, vibration levels and balance engine outputs. The IML marine torque-meter can be found on numerous sizes of vessel from lifeboats to tankers, including the odd 100-foot luxury cruiser!
An IML MT system on a 655mm diameter shaft, and below it, a picture of the vessel to which it was fitted.
Power Generation
Supply to this industry has mainly been standard torque transducers for boiler feed pumps and ancillary drives, but one of several specials is used on a 3MW wind turbine in Canada. The applications here show one standard and one non-standard transducer.
A boiler feed pump drive with a torque-measuring coupling.
A special torque transducer with mechanical overload protection for a swarf retrieval winch in a nuclear power station.
|
 | Fact Sheet | | | Nature of Business | : | Manufacturer, Exporter | | Major Markets | : | Indian Subcontinent, East Asia, Middle East and South East Asia |
|
|
Contact Details | Company Name:
 | Industrial Measurements Limited | | Contact Person: | Mr. Manager | | Telephone: | +(91)-(22)-27792776 / 27790919
| | Fax No: | +(91)-(22)-27790819 | | Address: | Summit House, Plot No. B-23, Sector 4, Near Shriram Vidyalaya, Navi Mumbai, Maharashtra - 400 708 (India) |
|
|