These manufactured by us undergo three manufacturing stages namely Heading, Thread rolling and Blackening. We use high grades of Steel and other metals to fabricate precision bolts. After the fabrication of the bolt an anti-corrosive layer is applied to stop oxidation, thus making it corrosion resistant.

This  type of hardware fastener with a threaded hole. Nuts are almost always used opposite a mating bolt to fasten a load of parts together. The two partners are kept together by a combination of their threads' friction, a slight stretch of the bolt, and compression of the parts. Nuts are graded with strength ratings compatible with their respective bolts.

We use various grades of raw materials like steel, alloy steel, mild steel, brass and other metals to construct precision machined components. Our products are carefully fabricated to present premium quality components with high tensile strength and tolerance, corrosion resistance, tamper proofing and many other features.

We fabricate different types of threaded components catered to various engineering industries. These threaded components can be either made from tapping method or by rolling. The process of cutting the threads in a hole is called "tapping" the hole. The die cuts a thread on a preformed cylindrical rod. To achieve great strength, the threads are rolled. Rolled threads have the advantage of increased strength along with reduced material cost as the bar or rod used is actually smaller than the finished size due to the material squeezing into shape.

We provide precision bolt lock washers, serving various industrial and commercial requirements. We also offer many other types of washers for different purposes. A washer is a thin disk-shaped plate with a central hole, which is normally used to distribute the load of a threaded fastener. It can also be used as a spacer, spring, wear pad, preload indicating device, and locking device. Rubber washers are also used in taps or valves where they form the seal that shuts off the flow of liquid or gas. Usually the outer diameter of the washer is about twice its inner diameter.

Studs in both soft and hardened condition are made by us. A stud is similar to a bolt but without the head. Studs are threaded on both ends. In some cases the entire length of the stud is threaded, while in other cases there will be an unthreaded section in the middle. It may be anchored in concrete, for example, with only the threads on one end exposed. We offer a wide range of studs which are used in diverse engineering and machine tool industries.

A fastener is a hardware device that mechanically joins or affixes two or more objects together. We manufacture clamp, clip, peg, pin, nail, clasp, screw anchor, wedge anchor, bolt screw, cap screw and many other industrial fasteners. We also offer various kinds of Rivets which fills the hole where they are installed to establish a very tight fit. Fasteners can be used to close a container such as a bag, a box, or an envelope; or they may involve keeping together the sides of an opening of flexible material, attaching a lid to a container and in many other industrial applications.