Industrial Product

Special features:

• VFD-V & VFD-HZ in dual display
• 5mscrest-max capture mode (peak hold)
• Autoranging relative -zero mode
• Display hold
• RF-detection (NCV)
• Beep-jack input warning
• Hz line level frequency
• HZ logic level frequency
• Diode test & continuity test

Large size Motors use Modern Technology for their operation. Instead of conventional Star Delta starters they use adjustable (veriable frequency) drivers. This gives high starting torque for the motors. But VFD’s also generate High Frequency Voltage & High Frequency Signals. These signals if measured by an ordinary TRUE RMS Multimeter will give incorrect readings. For correct measurements, it is necessary to have a DMM which filters the High Voltage & High Frequency (carrier frequency) Signals & display the fundamental Voltage & fundamental Hz correctly.

This Clampmeter displays this readings correctly. Hence it is very essential for installation of VFD’s property.

Special Features :

• VFD-V & VFD-Hz function
• 5ms CREST-MAX capture mode (Peak Hold)
• Autoranging Relative -Zero mode
• Data Hold function
• EF-Detection (NCV)
• AutoCheck TM Voltage & Ohms
• Hz Line Level Frequency
• Manual / Autoranging range selection.
• Auto Power Off
• Diode Test & Continuity Test
• PC Interface (Optional)

Features:

• DC-20MHZ / DC-30MHz
• Dual channels /dual traces, X-Y mode
• 6” display, high brightness Toshiba oscilloscope tube
• High sensitivity of triggering,up to 1mV/divison
• Ch1 channel incremental magnification function for clearer observation
•   Than ordinary oscilloscope
• TV synchronous separation circuit for displaying stable TV signal
• Trigger mode : AUTO/ NORM / TV-V/ TV-H
• Vertical : CH1/ CH2 /ALT/ CHOP/ADD
• X-x10 / Y-x5
• Polarity inversion
• Ch1 Sync output

features:

• dc-20mhz / dc-30mhz
• dual channels /dual traces, x-y mode
• 6” display, high brightness toshiba oscilloscope tube
• high sensitivity of triggering,up to 1mv/divison
• tv synchronous separation circuit for displaying stable tv signal
• trigger mode : auto/ norm / tv-v/ tv-h
• vertical : ch1/ ch2 /alt/ chop/add
• x-x10 / y-x5
• polarity inversion
• ch1 sync output
• power supply : ac 220v (110 optional)