Air Cure Mould Releases & Antistick

Our organization is engaged in manufacturing and supplying an extensive range of Air Cure Mould Releases & Antistick. These colorless Releases & Antistick are solvent based dispersion of solid active ingredients and exhibits low friction and excellent antistick characteristics. The releases are applied on the heated surfaces of silicone and fluororelastomers, which furnishes dry colorless coating. Further, these are also effective for releasing rubber and plastic compounds and provide multiple release cycles without transfer to molded parts with no buildup on the mold. The Air Cure Mould Releases & Antistick coatings are available in 1Litre, 3.5Litre, & 20Litre containers as per the client’s requirements.

How to use:

• To ensure optimum release results, mold surfaces should be cleaned by solvent such as acetone, or toluene and dried prior to molding
• The molds can be sprayed, dipped, washed or brushed with the coatings
• Two coats should be applied on the mold and are left for drying before the application of another coat
• These solvents are flammable, and thus, the product should be kept away from heat, sparks and flames
• Adequate ventilation should be employed, especially in enclosed areas
• Smoking should not be permitted and contamination of tobacco products should be avoided

Properties:

• Effective for all types of rubber and plastics compounds
• Particularly recommended for silicone and fluoroelastomers
• Clean, dry, colorless, and non-oily
• Contains no oil, grease, stearates, waxes or silicones
• Requires no curing step
• Will not transfer to molded part
• Will not lead to build-up on the mold
• Will not interfere with post-furnishing operations
• Will not cause knit lines on molded parts
• Gives multiple releases per application
• Chemically and thermally stable
• Usable to 5000F
• Leads to increase productivity and reduced scrap rate