We are the distributors of panel PC with TFT LCD screen. They are available in sizes of 12’, 15’, 17’ & 19’ size. The rugged panel PC with touch scree is suitable for industrial use. Features: •Computer w/ Intel® Celeron® M 1GHz/0KB •Resistive touchscreen •Slim CD-ROM •NEMA 4/12(IP65)- compliant front bezel •Built-in CD-ROM driver or Combo driver(optional) •One PCI expansion slot •Built-in speakers •4 USB 2.0 ports •Resistive – Capacitive type of touchscreen •Optional variable system stand or VESA FPMPMI ARM to meet diverse application environments.

We are the distributor of industrial computer & workstation with latest AXIOMTEK PICMG.

Features:

•1.3 single board computers with high performance Intel® Pentium® 4 and low power Intel® Celeron® processors
•Two 240-pin DDR2 DIMM slots support up to 4GB memory capacity
•Four Serial ATA port support data transfer rate up to 300MB/s
•CompactFlash™ Type II socket on board
•LVDS connector on board (optional)
•Built-in 6 USB ports (2 ports on I/O bracket
4 ports by pin-header)
•CHASSIS: Three 5.25" and max. two 3.5" disk drive bays
•One 12cm ball-bearing fan (optional two 12cm fans)
•Supports 14-slot back plane or ATX MB
•Hot-swap redundant power supply supported
•Built-in centralized sensor module (only AX6156E).

We are the distributors of PID controller, SSR & SCR which is suitable for industrial control applications.

Specifications:

PID controller

• Input : K, J, Pt, R, S, N, T, E, B, DC linear.
• Output : RELAY(250V/5A), DC24V, DC linear
• Control : PID, ON/OFF
• P Band : 0%-200% full Scale
• Cycle Time : 0-100 Sec.
• Accuracy : 0.3% Full Scale
• Power Supply : AC 85V~265V, 50/60 HZ , 24V DC
• 1/4, 1/8, 1/6 DIN Sizes.
• Two-point alarm, with 16 alarm modes.
• Auto/Manual tuning switchable.
• Sensor Break display indication, "open"

SSR

• Load current ranges from 10 to 40 Amps.
• Internally mounted snubbed circuit protection for huge current(dv/dt) application
• Zero Crossing turn-on, Zero current turn-off.
• With LED display to detect the operating of devices.
• Photo-isolation, 4000V Rms isolation.
• R SERIES have output power 0~90%
• Ambient Temperature : -10~55oC.

We are a leading distributor of short range radio modem which is suitable for communication between PC's, instruments, USB and RS232. These wireless modules are short range radio connectivity applications based on 2.4GHz ISM band FHSS wireless technology.
Our handy port series is one of the most cost-effective and robust cable replacement total solution in the market.

•HPS-120 is an external adapter type wireless serial(RS-232) transceiver for existing DB-9 interface.

•HPS-110 is an OEM module which has SMA type external antenna and RS-232 interface for metal housing facilities.

•HCS-100 is an small form-factor OEM module which has internal antenna and TTL(UART) interface for plastic housing facilities.

HPU-100 & 120 are USB interface type transceivers for PC which can support multiple(up to seven) wireless serial connections by working with any combination of above serial transceivers. The service range is 100 ~ 1,000m scalable according to the antenna types and the operational temperature range is -20 ~ +75C.

We are the distributors of Multi port RS 232 /RS422/ RS 485, PC add-on card PCI & ISA Bus. The PCCOM PCI bus 4 port adapter is an 32 bits PCI bus board with Plug and Play (PnP) features, it provides four asynchronous serial communication ports (RS232 or RS422 or RS485), which link the computer and serial peripheral devices such as terminals, modems, serial printers, plotters etc.

The PCCOM PCI bus 4 port adapter is particularly suited to facilitate the connection of terminals (VDUs) in multi-user operating systems. The PCCOM board may be installed in any Pentium or hardware compatible systems. The PnP features let hardware configuration for IRQ and I/O address is detected by BIOS automatically, you don't need set switch and jumper. Since most of the computer has its own COM1 and COM2, the PCCOM PCI bus 4 port adapter can be configured from COM4.

We are a leading distributor of VORTEX / VIA / EDAN processor based embedded card, fan less operation. We can offer following embedded hardware & software.

ICOP 6042 Embedded Vortex86 166MHz System-on-Chip half-size SBC with 2S/CRT/LCD/Ethernet/64MB SODIMM
ICOP 6070 / 6071 PC/104 Embedded Vortex86 166 MHz System-on-Chip CPU Module with 4S/CRT/LCD/Ethernet/Audio/128MB SDRAM on board. EBOX 3800/3850 On-Board VIA EDEN Nano 800Mhz (Fan less), On-Board 256MB DDR266, On-Board 10/100Mbps LAN, On-Board Audio, 1 x UltraDMA 44p IDE connector, 2 x USB 2.0 ports (one on front), 1 x RS-232, 1 X PRT, Support 2.5 Inches Hard Drive Device
Windows CE.NET Development Kit-NEW
eBox-II Windows CE.NET Development Kit with Vortex86 Board Support Package, Prebuilt image, KVM Switch and Step-by-Step hands-on lab instructions.

We are the distributors of 8K series embedded controller for industrial application with PLC type ADON modules for analog and digital I/O. The I-8437 / 8837 provides Ethernet & serial DAS solutions. It contains 4 communication ports. These different communication ports can provide different kinds of usage include RS485 networking, controller to controller data-exchange, Mod bus / Mod bus TCP protocol, remote I/O extension, linking with HMI / MMI, program download / upload and debugging, Remote IO modules are useful for some distributed applications. The I-8417 / 8817 / 8437 / 8837 can integrate with the I-7000 and I-87xx modules by linking one of its COM3 or COM4 ports to each remote I/O module. A max. number of 64 remote I/O modules can be linked to one controller and max. number of 16 I/O channels for some remote I/O modules. These Controllers Can be ISaGRAF Embedded controllers which is a powerful soft PLC.

We are a leading name in distribution business of PCI / ISA bus DQ cards for hi speed DAS, drivers for NI, VB & VC software.

The PCI-18xx series is a family of high performance data acquisition board for PC with PCI bus. It features a continuous, 330KHz, gap-free data acquisition under DOS and Windows. The PCI-1800 family has the same architecture and has, two 12-bit D/A output channel, 16 digital input channels,16 digital output channels. The PCI-1800H,PCI-1800L provide 16 single-ended or 8 differential inputs. The PCI-1802H, PCI-1802L provide 32 single-ended or 16 differential inputs. The -H means high gain model and the -L means low gain model. The scan function of PCI-1800 is so amazing. We call it Magic Scan. The variable channel scan function is found in some famous data acquisition board. Compare to Variable channel scan, the Magic Scan improve a lot function and meet the demand of high end user. The Magic Scan mechanism not only scan the different input channels at vastly different rates, but also at different gain. Even in multi-channel scan, the sampling rates can maintain at 330KS/s.

We are the distributors of Remote 7K DAS module for analog/digital I/O. OPC / DDE drivers for SCADA interface. RS232/422/485 converters/repeaters.

I 7520R model is used for PLC user. The design of isolation between I-7520 and I-7520R is different. If the user want to supply the power from PLC, he should use the I-7520R. Otherwise the isolation will be broken. For Supply from PC side Use I 7520.
We offer RS 232 to RS232 Isolators, RS232 to RS 485/RS422 Converters, RS 422/RS485 Isolators, USB to RS 232 /RS422/RS485 Converters which will work for all software with powerful flawless software drivers.
Analog & Digital I/O Remote DAS Modules for all field Inputs is available.

We are the distributors of Internet IP CMOS Camera, CCD camera, standalone & PC based DVR for home & office.

iCAMView is a compact stand-alone web-server capable of remote video surveillance. It can be accessed from anywhere in the world via a standard browser by entering the IP, login and password. Each system can simultaneously support any two types of USB PC cameras be it regular, infrared or pan-tilt

iCAMView is an affordable solution to your surveillance and security needs. It is developed based on network technology. With this device, the user can stream live video images directly to the Internet without a PC. iCAMView allows the user to do Motion Detection, Scheduled Image Recording, Assign 8 User Account, Save video, make PPPoE connection with Dynamic DNS capabilities, View multiple cameras simultaneously, Manage your User Accounts/Bandwidth/Camera, and lots more.

SA-270 P-T-Z camera that delivers extraordinary capabilities in both image quality, and day-to-day performance. SecuMaster SA-270 is an intelligent indoor high speed dome camera specially designed for warehouses, banks, stations, casinos, parking lots, supermarket, hotels etc. security uses.

SA-270 is using new generation advanced DSP low Lux camera with 27X optical zoom and 10X digital magnifier to provide an ideal solution of high performance and reliability.
With Pan and Tilt, 360 degree continuously rotation and over 180 degree auto turn around, and 480 TV lines resolution functions, SA-270 can be easily installed in various applications to secure your lives.
Through the embedded RS-485 communication protocol, SA-270 is fully compatible with our Our and other DVR system or IP servers to control P-T-Z camera preset, zoom in/out, iris, speed from server or remote side.

We are the distributors of signal isolators & conditioners for all industrial inputs like: Mv, mA, RTD, TC, frequency, etc.

RTD/TC/STRAINGAGE/MV/V/I Single channel isolated Signal conditioner, Transmitter, output configurable as Voltage or Current, Din Rail Mounting, Supply voltage 10-30V Dc.

Single input dual outputiDIN 1X2signal Isolation Transmitter,
Efficiency grade: 0.1A0.2A0.5B
International standard signal input: 0-5V/0-10V/1-5V, 0-10mA/0-20mA/4-20mA
Output internal signal with high load capabilityF 5V/0-10V/1-5V,0-10mA/0-20mA/4-20mA and so onB
Extremely high linearity in whole processiNonlinearity<2%j
DIN 1X1 V/F Transmitter Change the input signal into unit impulse signal
Efficiency grade: 0.1A0.2A0.5B
International standard signal input: 0-5V/0-10V/1-5V, 0-10mA/0-20mA/4-20mA
Standard signal outputF 0-5KHz/0-10KHz/1-5KHz and so onExtremely high linearity in whole processiNonlinearity<2%j
Signal input/output/ Accessorial power supply

We are the distributors of electrical transducer & transmitter for voltage, current, power & single & three phase, with analog o/p & mod bus o/p for various range.

Element AC Multi-parameter Digital Transducer
• Input (measuring range: AC 45-65Hz, voltage: 110V, 220V, 380V and 500V(or specially supply to meet user's other special requirement), current: 1A, 5A, 15A, 25A (or specially supply to meet user's other special requirement)
• Data output: RMS of voltage V, RMS of current I, frequency F, active power P, reactive power Q, power factor cos?, active energy, and reactive energy.
• Output interface: RS-485: 2-wire connection, communication distance: 1200m, ±15KV ESD protection. RS-232C: S3 case style connects to special RS485/RS232C converter.
• Accuracy grade: Frequency 0.05 Hz. Voltage, current, power factor, active power, reactive power, active energy, reactive energy: 0.5% grade. (Accuracy and linearity are ignored when the voltage is below 5%.)
• Baud rate: 1200, 2400, 4800, 9600, 19.2K bps
• Refreshing period: 250mS
• Isolation voltage: 2500V DC
• System power consumption: <200 mw (+12V)
• Power source: +5V, +12V, +15V, +24V, +48V DC,220V AC DC(please specify any one of the five options in you order)
• Operation temperature: 0°C ~50°C
• Storage condition: -20°C ~+80°C (RH: 5%~95% no dew)
• Case style: S3(Window :?6.5 ), N ( no window)
• The address and baud rate of the transducer can be modified by use of software.