Level Switch

Float type Level Switches are available in Side Mounted versions and Top Mounted Versions.
These type of Level Switch are suitable for Non-Magnetic Fluids only.

Process connection             : Flanged, Thread end, Triclover clamp type or, L shaped clampt type

MOC of Float, Stem and Stoppers: SS 304 , SS 316,  PP, Teflon etc.

Terminal Housing                 : Aluminium Housing, Flameproof Housing, DIN Plug or, Flying Leads

RF-ADMITTANCE Point Level switch is a Drive Shield, Coat Guard single point level switch. Fail Safe logic is field selectable. The Integral /  remote electronics control unit  is possible. These switches are suitable for any slurry, paste, conductive or, non conductive granules, pallets powders etc.

The quoted instrument is a single point switch, for each switching point one unit is to be used.

Service : Effluent

Housing : Weather Proof, Cast Aluminium Or, Flameproof

Mains : 230 V AC or, 110 V AC 50 Hz

Output : 2 set of C/O contacts rated at 5 amps, 230 V AC for resistive loads.

Probe : Integral / Remote

The system is a 1 probe, 1 Switching unit for single predetermined point., i.e. Point  Level  Switch

Service              : Only for Conductive Liquids

Output                : 1 SPDT rated at 5 amps, 230 V AC for resistive loads.

Probe                 : Integral or, Remote

Mounting                  : Screwed,1/2" BSP (M), SS

Sensing               : SS Rod

Insulation            : PTFE

Probe Length   : 150 mm  ( Suitable for side mounting)

Vibrating Fork type Level Switches are single point level switches. The electronics control unit is integral with the sensing probe. Fail safe logic is field selectable.

There ate two type of Vibraing Fork Level Switches - Vibraing Fork for Solids

                                                                                     Vibrating Fork for Liquids

Housing                     : Cast Aluminium Weatherproof

Mains  :                      : 230 V AC or, 110 V AC 50 Hz

Output :                     : 2 set of C/O contacts rated at 5 amps, 230 V AC for resistive loads.

Rotary Paddle type Switch is a single point level switch. The electronics control unit is integral with the sensing probe. Fail safe logic is field selectable. The instrument is suitable for free flowing powder / gains / sand etc. This instrument is not suitable for liquid.

Housing                      : Cast Aluminum

Mains                         : 230 V or, 110 V AC 50 Hz

Output                        : 1 set of C/O contacts rated at 5 amps, 230 VAC

                                      (On special request 2 sets of C/O Contacts)

Mounting                     : Side mounted or, Top mounted versions

Motor type                            :  Micro Synchronize 2W,230 V AC, 1 RPM