Ozone Generator Accesories
It has two cylinders filled with zeolite which selectively adsorbs the nitrogen in the air. In each cycle, air flows through one cylinder at a pressure of around 20 psig, where psig indicates the gauge pressure (138 kPa, or 1.36 atmospheres) where the nitrogen molecules are captured by the zeolite, while the other cylinder is vented off to ambient atmospheric pressure allowing the captured nitrogen to dissipate.
Typical units have cycles of around 20 seconds, and allow for a continuous supply of oxygen at a flow rate of up to approximately five liters per minute (LPM) at concentrations anywhere from 25% to 95%. This process is called pressure swing adsorption (PSA). Since 1999, concentrators providing up to 10 LPM have been available for high flow patients, in sizes not much larger or heavier than 5 LPM concentrators.
These diffusers are installed within minutes and produce thousands of tiny bubbles providing good oxygen & ozone mass transfer. Requires low driving pressures (0.25-PSI). Made in the USA!
Our Static mixers are a series of geometric mixing elements fixed within a pipe (tube), which use the energy of the flow stream to create mixing between two or more fluids. Throughout the years Koflo has optimized the design of our static mixers to achieve the greatest amount of mixing with the lowest pressure loss possible. Whether your application involves low viscosity fluids, high viscosity fluids, fibrous materials, or just the need for a quick flash blend, we have a static mixer design available to optimize your blending process.
To,Ozone Feed Systems