The energy saver is designed specifically for industrial lighting load ie halogen lamp, mercury vapour lamp, bunch of tube light etc. The energy saver can save energy when connected in between M.S.E.B and any lighting load.
The concept of energy saving is based on the principle of controlling the voltage applied to the given load an reduce the drop across the choke connected in series with the lamp. All lamp as named above have a choke in series. When the lamp is switched on the choke stores energy in it and a high voltage is developed which ignites the lamp, once the lamp is ignited the choke is used only to maintain a steady current to the lamp. The lamp once ignited does not require such a high voltage to keep it glowing thus the voltage drop across the choke results in waste of energy. By reducing the applied voltage the drop across the choke can be reduced and energy can be saved.
The Secura energy saver is digital microcontroller based and works on the basic principle of a servo controlled voltage stabilizer where in stabilized voltage at the output of the saver can be programmed with respect to real time clock.
The energy saver is provided with 25 set points where the output voltage can be set with respect to real time. The number of set points required is also programmable. The saver is also provided with six relay potential free contact which can be switched on and off with respect to real time. Each relay can be programmed for three on and off timing ,the number of on /off timing required per relay is also programmable.
The relay outputs can be used to switch on/off any load such as water pump etc. at a particular time hence enhancing the saving mode.
Note: relay is an optional feature.

Capacity Range Of Three Phase: 15KVA To 500KVA – Oil Cooled. Customaries I/P & O/P Range.

Features:

• Auto / Manual Operation With O/P Voltage
• Raise & Low Push Buttons
• Miniature Pot To Set O/P Voltage
• Separate Load On / Off Push Button Switch
• Auto Load On With Customaries Timer
• Delay (optional)
• Fully Solid State & Single PCB Design
• Incorporating Protections, Control
• User Friendly Front Panel With Separate
• I/P & O/P Voltage Metering With Phase Selector Switch, And Phase wise High Voltage, Low Voltage, Ok, Output On Indications
• Ac Synchronous Motor Coupled With Variac To Facilitate High Rate Of Voltage Correction
• Silent Operation, construction Convenient For Easy Serviceability
• Proper Ventilation & Cooling Method Is Used As Per Models
• Cable Entry For Proper Gland Plate
• Castors To Facilitate Transportation

Protections:

• Under Voltage As Well As Over Voltage
• Over Current Trip By MCCB, ACCB
• High Voltage Surge Protection
• No Distortion In Waveform
• No Effect Of Variation In I/P Supply, Load PF On O/P Voltage Setting

We offer wide range of bridge rectifiers which are use to convert the AC to DC current. These can be also customised as per client's specific requirements. Our range of bridge rectifiers includes:

• Half Wave Bridge Rectifiers
• Full Wave Bridge Rectifiers

Capacity Range: 1KVA To 3KVA
Backup Time: 30minutes to 8hrs.
Battery Voltage: 24VDC, 36VDC, 48VDC depends on model.

Features:

• Wider I/P Voltage Range: 140VAC To 270VAC
• O/P Voltage Range: 200VAC To 245VAC
• Instantaneous Switch Over & Sensitive Switch Back
• Cold Start Facility
• SMPS Based Battery Charger For Safe And Longer Battery Life
• Compact Design
• Most User Friendly
• Easy To Install & Use

Protections:

• Under Voltage / Over Voltage Cutoff
• Protection to Prevent Battery Deep Discharging
• Protection For Battery Over Charging
• Audio Signals For Battery Low, Changeover Mains To Inverter
• Surge & Spike Protections

Over Load Protection On Inverter & Short Circuits Protection On Both.