Stainless steel coils are used widely all over the world. We also supply cut-to-width strips especially for welded pipe industry.

Thickness : 0.40 mm to 3.00 mm in CR condition.
Width : 525mm, 1000, 1200 and 1220 mm. Occasionally 1250 mm.

We also provide strips in cut-to-width sizes like : 50 mm , 100 mm … etc up to 610 mm.

Coil Weight : From 100 kg to 5000 kg.
Finish : 2B, 2D
Available in : Commercial quality.

Stainless steel pipes and stainless steel welded pipes. Diameter : 9.5 mm to 50 mm. Thickness: 0.40 mm to 2.0 mm. Finish : Bright or Brush. Length : 5.8m or cut-to-length. Grade : 201, 304 etc.

Stainless steel pipe fittings
like: flanges, elbows, bends, tee joints etc made from welded stainless steel.

Grade : 201, 304.

Patta : Patta is irregular form of sheet which is used in manufacture of house ware / kitchenware & furniture.

Please note that the edges of this product are untrimmed and the ends are uncut.

Thickness : 0.40 mm to 2.00 mm in CR condition.
Width : 250 mm to 610 mm (buyers choice).
Length : The length of patta varies from 2000 mm to 2400 mm since the ends are un-cut.
Finish : 2D
Available In : Commercial, DDQ and EDDQ quality.
Sheets : Sheets are rectanglar in shape. The shape and specifications are as per international standards.
Thickness : 0.40 mm to 3.00 mm in CR condition.
Width : 1000, 1200 and 1220 mm. Occasionally 1250 mm.
Length : 2400, 2500 mm.
Finish : 2B, 2D
Available In : Commercial quality.

Circles are circular blanks cut from patta / sheets. This is a ready-to-use product as it does not require any further cutting or resizing. Thus there is no scrap generation. Hence it is more cost-effective than sheets or coils.

Thickness : 0.40 mm to 2.00 mm.
Diameter : Buyer's Choice :- 100 mm to 600 mm.
Finish : 2D

Rectangles are rectangular shaped blanks cut from patta / sheets. This is a ready-to-use product as it does not require any further cutting or resizing and can be customized to suit your requirements.

Length : From 300 to 2000 mm.
Width : 50 to 600 mm.
Thickness : 0.3 to 2 mm.

Does your factory requires any other 'shape' cut from sheet metal as an input material? If yes, then let us know the shape by sending us the drawing or picture by email or fax and we shall do our best to give you the exact or nearest to that shape of sheet metal.
We call these odd shaped sheets as 'blanks'. We can supply these blanks as per your design or drawing.

Thickness : 0.40 mm to 2.00 mm.
Shape : As per your requirement.
Finish : 2D

We also undertake contract-manufacturing of semi-finished or fabricated components of Sheet metal made by Pressing / spinning process as per your design / drawing.

The advantages of ordering semi-finished / fabricated components are:

• The scrap generated during sheet cutting remains with use. So you do not pay any charge or duty for this scarp.
• The breakages/ wastages of the components remain with us. Only 100% ok products will be shipped to you.
You do not have to take care of the factory /machines/ labour etc.
• Since labour costs in India is less, you get the cost-advantage to out-source your manufacturing to India.