Circular Saw Blade

For Precise ripping cuts in naturally moist solid woods.

* On molding machines or gang - rip saw with one or two shafts

* for dry and Planed woods

*thin kerf for littile waste

* Tooth configuration: Flat "F"

* Cutting Material: HW HL Solid 20

 

For Precise ripping cuts in naturally moist solid woods.

* On molding machines or gang - rip saw with one or two shafts

* for dry and Planed woods

*thin kerf for littile waste

* Tooth configuration: Flat "F"

* Cutting Material: HW HL Solid 20

For trimming of plastic, veneer and solid wood edges.

1. On edge banders and edge trimming machines

2. Design with positive or negative hook angle

3. Shear angle

4. Tooth configuration : top level

5. Cutting Material : HW HL board 06

 

For Trimming and cross cuts in solid woods and panel materials.

* On table saws

* tooth configuration : Flat “ F’ / ATB “ WS”

Cuttig Material : HW HL Solid 20 / Solid 10

 

For Sizing Cuts in panel materials / ripping and cross cuts in solid woods

• On Table saws, panel saws and cut – Off saws.

• Various numbers of teeth allows for optimal quality of cut, feed rate and adjustment for material thickness.

• Tooth configuration : ATB “ WS”

• Cutting Material : HW HL Board 03

For sizing cuts in panel materials raw and veneered, Foiled or melamine.

* On panel sizing saws and in combination ith large hoggers on double - end tenoners.

• * Specially for raw particle board, veneered particle board, hard fibre board, MDF panels and high- density plywood in single sheets.

• * On panel – sizing machines for cutting single sheets or stacks up to 100 mm.

• * Tooth configuration: ATB “ WS” / Flat with Chamfer “F-F”

 

For Scoring of plastic laminated panel materials

• On Panel sizing saws with scoring device.

• Height adjustable to kerf of main saw blade

• 1 mm scoring depth: . 17 mm wider than main saw kerf

• Tooth Configuration: Conical ATB “ KO- WS”

• Cutting Material : HW HL Board 03

For cross cuts in naturally moist and dry solid woods.

• On chop and miter saws

• Negative hook angle for clean cuts and safe handling.

• No kick – back

• Tooth Configuration : ATB “ W S”

• Cutting Material : HW HL Board 10 / HW HL Solid 20

 

For dividing and miter cuts in aluminium and plastic profiles.

• On Chop and Miter saws

• Positive hook angle requires tight clamping of work piece.

• • Tooth configuration : chip flat TR – F

  • Cutting material : HW HL board 10

<!-- @page { margin: 2cm } P { margin-bottom: 0.21cm } -->