Kahn racks, bottles or flasks of different sizes can be shaken by adjusting the compartments provided on the shaking rack. The rate of motion is by means of heavy duty DC motor which can be adjusted form 140 to 250 rpm by electronic speed regulator. These are available in the following sizes: • 20 x 13 x 4" • 31 x 17 x 4" • 36 x 18 x 4" Optional Accessories: • 0-60 minutes timer • Digital rpm indicator

These are specially recommended to meet B. O. D. demand of sewage & also for preservation of vaccines at low temperature. Construction:
• B. O. D Incubator super automate consists of a double walled chamber fitted with cooling & heating system.
• Outside is of mild steel with intervening walls of G.I Sheet/ aluminium.
 • Outer mild steel wall is finished in attractive enamel, 75 mm superior quality glass wool insulation prevents heat losses
Features:
• Temperature System: The automatic control sysytem controls the heating/ cooling circuits according to environmental temperature. If temperature of the environment falls below the working temperature, the unit will automatically switch on the heating system and cut out cooling.
• Cooliing Circuit: These are supplied with very high quality condenser, motor fan etc. ISI marked condensing unit system equipped with an overload relay to sustain reasonable voltage fluctuations in the given range of 220 V single phase, 50 Hz.
• They are equipped with a time delay mechanism to prevent rapid switching on/ off of the compressor on achievement of set temperature, giving it adequately the desired rest thereby prolonging its life. Optional Accessories:
• Inner illumination with 3 nos. fluorescent tubes
• Arrangements for CO2 and air mixture nozzle
• PID Microprocessor based controller with computer interference with software Sizes of the Working Chamber:
Made of SS- 304

	Width	Height	Length
4.1 CFT	455 mm	610 mm	410 mm
6.0 CFT	505 mm	830 mm	415 mm
10.0 CFT	570 mm	875 mm	550 mm
12.0 CFT	650 mm	900 mm	550 mm
15.0 CFT	700 mm	900 mm	650 mm

These are fitted withF. H. P motor having speed regulator and maximum speed 4000 RPM with perforated S. S Disc. The unit is having arrangement for moving in horizontal and vertical direction. These complete withstand, disc, etc to work on 220 V AC..
These are available:
• With 1/ 20 H.P. motor and S. S disc and speed regulator.
• With 1/ 4 H.P. heavy duty motor and speed regulator.
• With 1/ 2 H.P. heavy duty motor and speed regulator.

Constructed out of thick wooden board with exterior surfaces duly covered with laminated sheet. The work table is covered with stainless steel of 304 grade & the table is fitted with a stainless steel sink provided with tap connection & also a provision of water outlet. The working working chamber is provided with fluorescent light for good quality of visibility while working. The space underneath the work station is provided with storage compartment for general purpose. These are made of the following: I. Exhaust System : A special type exhaust system with heavy duty motor for a duct upto 10 ft. is fitted to remove the fumes from the cabinet. II. Door: A counter balanced sliding door made of acrylic moves vertically up/ down through a counter balanced weight operated by a steel rope. III.
Control Panel: Panel is fitted in front of the cabinet with mains, mains indicator, exhaust system controller, light switch, socket switch etc. to work on 220 V AC. IV.
Optional Accessories:
• PVC fume duct per/ ft
• FRP lining on walls
• Lead lining on work and walls to use as RADIO ISOTOPE FUME HOOD
• Working table top covered with acid resistant ceramic tiles

This heating plate is very useful for continuous heating upto 350°C. Cast iron plate machined to a smooth & levelled surface is fitted on a robust mild steel body duly painted. The top of the plate is 20 cm Dia. The rating is 1.5 Kw. These are provided with a pilot lamp, energy regulator, indicators to work on 220 V AC. These are provided complete with a cord & ring.

Shivam Ultra Low Temperature Research Cabinets are elegantly designed deep freezers available in horizontal chest / vertical upright models for quick freezing and storing of blood specimens clinical samples, etc. at ultra low temperature. Construction: These cabinets are double walled construction. Outer body is made of mild steel duly powder coated & the inner chamber is fabricated of stainless steel of 304 grade. The gap between the two chambers is filled with PUF insulation which is the best insulating material for low temp. cabinets. The cooling coil is brazed inner chamber uniformly for better temp. accuracy. The ISI market CFC free compressor with motor, fan condenser, accumulator, etc. are fitted below the chamber. The top having double doors with lock & key system. The inner door is of perspex sheet & the outer door is made of mild steel & insulated with PUF insulation to avoid temp. loss. The whole unit is mounted on the castor wheel for easy movement of the cabinet. Temp. Controlled: Temp is controlled by microprocessor base digital temp. controller cum indicator fitted with solid state relay. Control Panel: Nicely designed fitted on the side of the cabinet having volt meter, main, mains indicator, digital temp. controller cum indicator.

We offer wide range of Muffel Furnace. The outer casing is made of thick mild sheet, painted with stove enamelled paint. The heating elements are made of high quality KANTHAL- A-1 wire & embedded on the ceramic muffle with high grade refractory cement and backed on high temp. The furnace is insulated with ceramic fibre insulation which avoid the heat loss & makes the furnace light weight in comparison to the tradition furnaces. Control Panel: The furnace is complete with energy regulator, pyrometer, silver fuse, neon indicator to work on 220 V AC 50 Hz.
Maximum Temperature:
• Furnaces of maximum temp. 1000°C the working temp. will be 950°C
• Furnaces of maximum temp. 1200°C the working temp. will be 1150°C Optional Accessories:
• Digital Temp. controller in place of pyrometer
• PID temp. controller in place of pyrometer

This type ovens are designed for working upto 350° / 450°C.
These are offered with the following features:
• These are tripled walled construction. Outer body made of heavy mild sheet duly painted.
• Inner chamber made of thick S. Steel sheet with adjustable wire mesh trays.
• The middle chamber is made of Galvanized Sheet.
• The steel tabular heaters are placed in the middle chamber .
• The air is circulated between the middle & the inner chamber by a heavy duty Belt driven geared with a cover.
• Temp. is controlled by PID / Digital temp. controller cum indicator fitted on the side of the oven
• Control Panel is provided with MCB main indicator, heating indicator, temp. controller, switch for fan.
• To work on 220 Volts / 440 V 3 phase
• The unit is places on a movable trolley

Chamber Size	Trays
14x14x14 (350x350x350 mm)	2
18x18x18" (450x450x450 mm)	2
24x24x24" (605x605x605 mm)	2

We offer V. D. R. L Rotators. These are used for V. D. R. L test, blood grouping tests or for mixing of solutions in small bottles, flasks and beakers. It has a platform of size: 300 x 300 mm and can accomodate blood bottles slide or flasks using spring holder. Outer body is made up of mild steel duly painted. The speed is variable maximum 180 RPM & is a DC motor driven without any noise or vibration.

Optional Accessories: 0-60 minutes time

These vertical models have laminar air flowing down vertically from top towards the worktable. These are supplied complete with Static Finish Sunmica Table Top, transparent front door static Pressure Manometer, Built- in U. V. germicidal light & Cock for gas, Air or Vacuum Line. An optional arrangement of exhaust system for exhaust duct upto 6 ft can also be provided for such application where environment and user protection is required. A plenum is provided at the perforated stainless steel working table with exhaust system. The exhaust system works with the main air flow system These are available in the following sizes:

• 2' x 2' x 2'
• 3' x 2' x 2'
• 4' x 2' x 2'
• 6' x 2' x 2'

Optional Accessories:

• Virus Burn out unit for environmental protection
• Exhaust system
• Exhaust ducting
• HEPA filters exhaust
• Spare HEPA filters
• Spare pre-filters

Our Water Bath Incubator Shaker are offered with many salient features. These features are as follows:
• Double walled construction
• Outer body is made up of mild steel painted with white stoving enamel
• Inner chamber & Hut shaped Lid made of thick Stainless Steel Sheet
• Temperature controlled by hydraulic thermostat from ambient to 100 degree /- 1°C
• Oscillating Stainless Steel tray with S.S Clamps to hold flask rides on ball rollers
• Shaking speed range from 40- 140 RPM controlled by speed together.

These are available in the following sizes:

• 275 x 275 x 75 mm
• 275 x 275 x 150 mm
• 275 x 275 x 150 mm

 Optional Accessories:
• Spare Stainless Steel Tray with Flask Clamps
• Digital temperature indicator cum controller
• Incubator Shaker with cooling system

These are made out of heavy gauge stainless steel sheet with concentric rings. Auto cut element is fitted to protect the same when water gets dry. These are fitted with water level nozzles. These are specially made to work on 220 Volts, AC. These are available in the following sizes:

300 x 250 x 100 mm	6 holes of 75 mm dia
405 x 355 x 100 mm	12 holes of 75 mm dia