Shivrudra Services

We offer high quality micro bor unit(mb 02)

We offer high quality micro bor unit(mb 03)

We offer high quality micro bor unit(mb 04)

We offer high quality micro bor unit(mb 06)

We offer high quality micro bor unit(mb 07)

We offer high quality micro bor unit(mb 09)

We offer high quality micro bor unit(mb 10)

We offer high quality micro bor unit(mb 05)

We offer high quality micro bor unit(mb 08)

We offer high quality bushes

We offer high quality gears

We offer high quality le fingers

We offer high quality micro bar

We offer high quality micro bor unit(mb 01)

We offer high quality micro bor unit(mb 11)

We offer high quality slides

We offer high quality spockets

We offer high quality tailstock

We offer high quality screws

We offer high quality spindle

We offer high quality clutch

electroplated diamond saws are advised for brake linings, asbestos, fibre and reinforced plastic, hard plastics, carbon etc. Metal bond saws are suitable for sawing and slitting tungsten carbide. Ceramics, quartz, glass etc. Slitting saws from 30mm dia to 400 mm dia can be supplied.

pcd cutting tools can be easily used to machine non-ferrous and non-metallic components. Diamond, in its purest form, is essentially carbon. Carbon is known to have an affinity towards iron at higher temperatures. These temperatures are quickly reached while machining at certain speeds. For this reason, diamond cannot be conveniently used for ferrous applications.

pcd tools are most frequently applied in the automobile industry – comprising both heavy and light motor vehicles. Some of the materials that have been cost effectively machined with pcd tools include: hypo and hypereutectic aluminum alloys, copper, bronze, babbit and abrasive plastic composites.

although machining ferrous material is not recommended for pcd tools, they can be successfully used for certain cast applications where high speed is not attainable and where cubic boron nitride (cbn), which is conventionally recommended for cast iron machining, cannot be used. In such applications, it is seen that pcd wears more slowly at lower speeds. When a critical speed is reached, it starts wearing faster because at this speed, the heat generated while machining is sufficient to cause the chemical reaction between iron and carbon. However, at low speeds, pcd tools have proved their worth on cast iron material by achieving much better results than conventional tools, maintaining high consistency and accuracy of the work piece for a very long time.

We offer high quality micro boring bar