1. pipe OD 38 mm
2. pipe OD 34 mm
3. solid dia 32 mm
Base size 150x150x6 (mm)
Available in Galvanised & Zinc Plated Finish

Our most popular frame is the general purpose ladder type frame known as the 5x5 frame. We
Our 5x5 frame measures 5' x 5' (1524mm H x 1524mm W x 42.2mm D x 2.3mm tube wall thickness). Our frames are available in Painted and Hot Dip Galvanized Finish
The height is an actual 5' while the width is 5' from center of hole to center of hole across the top. This pattern is the most common in the industry.

We strive for compatibility, with the highest possible interchangeability with other patterns, because we want you to be able to switch to Sonia Overseas brand scaffolding as easily as possible. What determines scaffold stacking compatibility is tube size as well as interlock spacing. Again, the pattern we chose is derived from the most popular old-school patterns in the industry.
From the top view looking downward you will observe a rectangular pattern with 7' spacing from frame-to-frame and a width of 5' (as stated above the frames have a five-foot width).
Our tube size is 1.625" outer diameter, so check your pattern. As long as your pattern is 5' x 7' with the same tube size our pattern will stack with your pattern.
Our scaffolding also has an interlock spacing of 27.75" from center-of-stud to center-of-stud. This matches the most prevalent patterns in the industry as well.

Our Brace is a tubular 2248 mm L x 25 mm D x 1.7 mm tube-wall thickness.
The ends are hydraulically flattened and a hole punched at exactly 88.75 inches center-of-hole to center-of-hole. The brace is then riveted in the center and is fully galvanized for a rust-resistant final finish.
This scaffold brace fits a stud spacing of 27.75 inches center-of-stud to center-of-stud on the frame, yielding a 71 frame-to-frame spacing, the industry scaffold standard.

Available in sizes 71, 91, 121 and other special sizes as per requirements.
Finish available:
1. Hot dip galvanised
2. Electrical galvanised
3. Red painted

71x71, 91x91 Finish : Hot Dip Galvanised Red Painted Electrical Galvanised

Available in sizes 71, 91 and other special sizes as per requirements.
Finish available:
1. Hot dip galvanised
2. Electrical galvanised
3. Red painted

Available in sizes 71, 91 and other special sizes as per requirements.
Finish available:
1. Hot dip galvanised
2. Electrical galvanised
3. Red painted

Available in sizes 71, 91 and other special sizes as per requirements.
Finish available:
1. Hot dip galvanised
2. Electrical galvanised
3. Red painted

Our Shovel, model no. is available in round and square shape with wooden handle.

Technical Specifications of our shovel are specified below:

Blade size: 320*225mm

Our edging knife, model no.is available with steel tubular pipe handle.

Technical Specifications of our edging knifes are specified below:
Blade Size Shaft Size
200mm 760mm

Our range of digging spade tools & forks are developed from carbon steel, epoxy coated steel heads, that are hardened & tempered. These are available with plastic, wooden or steel handle.

Technical Specifications of our digging spade tools are specified below:
Blade Size Shaft Size
280 x 180mm 710mm