J. S. Enggprojects Private Limited

JSE Rib Profile is 1020mm wide, coverage with 28-30mm deep ribs at 200-250mm centre to centre with two/three stiffeners in between rib.

JSE Rib profile incorporates male / female ends with fill return leg and anti-capillary flute at side-lap thus ensuring leak proof sheeting capable of efficient water drain out. The profile is also available in crimp curve form for semi-circular / arched roofing and flashing.

JSE Kliplock profile is designed to be fixed to roof purlin or wall girt with fixing clips which concealed during insulation and require no fastening holes through the shed.

As in Kliplock fixing method no screws are visible so there is no screw penetration. The Clips are fixed directly on the support with only 2 numbers fasteners per clip thus provide positive engagement in the ribs of the profile.

Kliplock profile is designed to be fixed roof purlin or wall girt with fixing clips which concealed during insulation and require no fastening holes through shed. As in kliplock fixing method no screw are visible so there is no screw penetration. The clips are fixed directly on the support with only 2 Nos.fasteners per clip thus provide positive engagement in the ribs of roofing.

Decking forming machine consists of uncoiler and its base, coil sheet guiding equipment, roll forming system, post-cutting equipment, hydraulic station, controlling system, supporter table. The corrugated profile sheet produced by this machine has high strength with big rib, which adheres well to concrete. It's best to be used as the floor of high buildings, and the cost of such floor is low.

This roll forming machine can rollform metal roofing sheet. After roll formed by this roll forming machine, the surface will be very smooth and beautiful without any scratch on surface. Rollforming process: uncoiler, rollforming, cut to length. Fully Automatic Control System with PLC. Easy operation: Key in the length and quantity on the control panel.

Technical specification

Coil Width : : 1200 mm

Tough Depth : 30 mm

Pith C/c : 200 mm

Covered Width : 1000 mm

Thickness 0.45 mm to 0 .8 mm

JSE 84R is meant for both for interior and exterior applications. The rounded edges on this profile create a special effect. Panels can be replaced for easy maintenance or for a new look can be imparted by changing colours. Special perforation designs allow for customized acoustic design.

Both for interior and exterior applications. The sleek panels add character to the room. Available in a choice of colours. The ceiling panel enhances furnishings and room arrangements, challenging your creativity. Variety of available perforations enable perfect acoustics to be designed in the room.

JSE 150F and 200F are meant for both interior and exterior applications. These flat ceiling panels add character to your room, building and canopy etc. The specially designed tongue and groove arrangement make the ceiling completely interlocked and airtight for a smooth look.

Tiles / Planks are available both with powder coated finish and coil coated finish and available in 0.50mm galvanized steel / 0.70mm aluminium. Tiles and Planks are available with following fixing systems.

Clip in tile - two sides of each tile are raised and pipped and stopped to ensure positive engagement into the spring tee yet allow demounting of individual tiles.

lay in system - the tiles have a flange on each end which lays on the exposed grid.

Wall Angle - Tiles / Planks are trimmed along the wall parimeter by means of roll formed steel or aluminium edge cover profile or required size.