Nozzles

Inline entry hollow cone spray nozzles are pattern with uniform distribution of finely atomized droplets. Smaller droplets in spray pattern than full cone nozzles of the same capacity at similar pressures.

Characteristic: One piece inline body with removable orifice tip

Design: Two Piece Construction

Application: Gas Cooling & Cleaning spray Drying, Desuperheating, Water Cooling, Fugitive Dust Suppression.

Flow Rate : 1LPM to 40 LPM
Pressure : 2.0kg/ cm² or specified
Spray Angle : 45⁰ to 120⁰

End Connection : 1/4" to 1/2" BSP/ BSPT/ NPT (m)

M.O.C. : S.S. 316, 304, Brass, PVC, PVDF, PP, Teflon

Oil Burner Spray Nozzles

Oil burner nozzles are available in fullcone & hollowcone spray pattern micro-finish of Tip & Disc seats permitting flow only through the slots of the disc, plus extremely close manufacturing tolerances, ensure accurate capacity control.
These nozzles are accomplished withfilter in order to provide highly efficient in depth filtration with one piece construction extra fine filter microns are supplied as standard on all small capacity nozzles.

Application: LDO firing in kilns of cement, sponge, Iron Plants & Dust suppression.

Spray Angle : 45⁰ 60⁰, 80⁰

Flow rate GPH at  5 to 7 bar Pressure: 0.75, 1.5, 1.75, 2, 2.5m3, 3.5, 4,5, 6.5, 10.5, 12.5, 15.5, 19.5, 24, 30, 40, 50, 55, 60, 70, 80, 100 GPH.

M.O.C. : SS 303

Dryfog Nozzles

Water Flowrate :

• 3 LPH to 40 LPH
• Air Pressure 5 bar below 8 CFM
• Droplet belo 50µ