Power Control Centres are used to distribute the power to the different parts of the plant / building / industry / township and controls the whole power supply from one single place. We offer PCCs as per the customized requirements.

Motor Control Centres are used to distribute the power through the panels to the different motor loads located at various parts of the factory / system - from one place through the motor starter fitted in the panel of required rating with full protection. The motors can be started form remote positions also.

We manufacture and supply Lighting Distribution Boxes that serve the purpose of distributing the power for the lighting system of the plant or individual needs.

We manufacture and supply Auto Mains Failure (AMF) Panel and it functions between grid supply and DG supply.

How it works:

When the grid supply is on, the DG is kept in standby mode but as soon as the grid supply fails, the grid breaker trips and the DG sets are automatically switch on and the DG breakers close and the supply is restored. When the grid supply restored, the DG breakers trip and within seconds the grid breaker closes and the supply is again restored. The DG sets are switched off after cooling time.

We offer Automatic Power Factor Control (APFC) Panels that maintain the power factor of the system automatically by switching the capacitor banks as per the needs of the system. It also maintains the desired power factor through the APFCR (Automatic Power Factor Control Relay).

We manufacture and install Auto Changeover Panels as per the desired requirements of the clients. The main purpose of Auto Changeover Panel is to changeover the system from grid supply to DG supply and vice versa without any manual operation.

Our range of Load Sharing and Synchronizing Panels are manufactured by using high quality raw materials. These can be availed from us at the industry leading prices. These panels synchronize the different DG sets as per the load requirement of the system. If the load increases, it switches on the other DG sets on by one and synchronizes with the system automatically through PLT (Panel Logic Control) and when the load decreases below the desired level, it automatically disconnects the DG sets one by one and switches off as per the load requirement.

We manufacture Starter Panels that are used to distribute the power through the panels to the different motor loads located at various parts of the factory / system from one place through the motor starter fitted in the panel of required rating with full protection. The motors can be started form remote positions also.

Bus Ducts are used to carry power from transformer to the panels or works as rising mains to distribute power from the panels to the different floors of the building. We offer bus ducts as per the desired requirements of the customers.

We offer Control Desks at the industry leading prices. These can also be availed from us in the customized forms. The control desks are used to control the operation of individual machinery or plants.

Feeder Pillars are basically outdoor type electrical panels designed for various purpose and needs. These are suitable to cater all the requirements of electrical, electronics and telecom industry.

We manufacture and supply Junction Boxes that are used to connect wires altogether. These are manufactured as per the desired requirements and are available in all the customized forms.