POE- D18, D24, D48, D12, D5
The POE-D18 is an advanced power supply / power inserter. The power supply is autoranging on the input and has a regulated 18 volt
output. It has overload and short circuit protection in addition to Ethernet surge suppression built-in. The POE-D18 come complete
with a standard 230 VAC power cord. Current Indicator (-CI) modesl features an LED that will be AMBER until current flows to the end
device which will turn the LED to GREEN. This is a good way to remotely monitor the connection between the POE and the end device
and indicate that the end device is turned on.
Features:
√
“Carrier Class” Power Over Ethernet System SOH
√
18VDC Auto Ranging Power Supply/ Inserter
√
Lightning/Surge Protected
√
Advanced Auto-Sensing Algorithm
√
Overload and Short Circuit Protection
√
Minimum Cross Talk and Insertion Loss
√
Advanced Switching Technology – Runs cool
√
Installation Schematic on Label
Description:
The POE adapter gives “carrier class” performance in a low cost system. With its advanced auto-sensing algorithm it will supply power
only to POE recognized end devices. This gives an added measure of protection against damaging equipment. The overload and short
circuit protection will shut down power immediately when a short circuit is detected without any damage to the POE system. Typically
in 100MB networks the maximum allowable CAT5 cable run is about 100 meters. This is not a limitation of the POE equipment but
rather a limitation of the Ethernet standards. Power is supplied on ethernet pins 4/5 (V+) and 7/8 (GND).
Product Family :
POE- D05
POE- D18
POE- D24
POE- D48
For Further Information Contact :-
DATCOM POWER OVER ETHERNET INSERTER
Applications :-
1. Remote routers, access point & bridges. 4. IP Camera Systems
2. Remote networking equipments. 5. 400 MHz sytem to 10 GHz systems.
3. SOHO Equipment 6. IP Phone Systems.