We are one of the leading manufacturer and supplier of electronic dual meter which is time based energy saver for 3 phase Air-Conditioners. EEE comes in two varieties Dual and Triple timer models, which switches ON and OFF the compressor at frequent intervals alternatively and results in saving of power and money.

Working Principle:

When the AC is started, both compressors will be switched ON with in-built 3 minute time delay. After that, 1st Compressor will be switched OFF for 3 minutes after running for 20 minutes and again switched ON at 23rd minute. Alternatively, 2nd compressor will be switched OFF for 5 minutes after running it for 25 minutes and again switched ON at 30th minute.

By switching ON and OFF the compressors alternatively EEE saves considerable amount of power and money.

We offer high quality power watches, which are an electronic automatic sequential timer and used for regulating the running time of air conditioners, electrical motors, geysers and agricultural pump sets more effectively and conveniently. These watches save energy by avoiding continuous running of these electronic gadgets. Apart from this, power watch comes as handy alternate for the clients who prefer to invest on models with remote control facility.

Our power watches are available with an initial in-built time delay of 3 minutes proper for all kinds of air-conditioners including the models where auto cutoff timer provision is also available.

If the rotary switch is kept in ON position, the A/c runs directly by-passing this unit. If rotary switch is kept in OFF position, it runs the A/c for selected ON time and switches it OFF permanently. In the Bi-color LED, green indicates ON and RED indicates OFF, instant start is provided to start the electrical gadgets without any time delay.

Power watches are provided with 2 rotary switches to set the ON time and OFF time individually. ON time can be set in slabs of 15, 30, 60, 90, 120, 180 and 240 minutes whereas OFF time can be set in slabs of 10, 20, 30, 45, 60, 90 and 120 minutes.

Power watches are suitable for ACs of all models up to 2 Ton (Single Phase) capacity & up to 3 HP single phase motors. Power watches keep filling the O/H tank from ground water by automatically operating the motor at desired time intervals.

We specialize in manufacturing and supply high standard swift electronic automatic phase shifters, which are widely demanded in the markets. These shifts find application in shifting the power from alive phase to the failed phase(s) instantaneously, thus keeping all the circuits alive. These shifters can be availed from us in standard as well as customized specifications to meet the requirements of our clients.

Features:

• Solid & state in Design.
  
• Fully automatic & No manual intervention
  
• Provides continuous supply even with one phase
  
• Compact in size and easy serviceability.
  
• Visual indication of input and output
  
• Shifts instantly within a second
  
• When supply resumes it restores to the normal position automatically
  
• Easy installation and no maintenance
  
• System can be concealed since it is transformer free.
  

Application Areas:

• Bungalows/ Flats
  
• Hospitals / Nursing Homes
  
• Marriage Halls / auditoriums
  
• Computer Centers
  
• Commercial Complexes
  
• Hotels / hostels
  
• Offices / Banks
  
• Laboratories
  
• UPS ( single Phase )
  

Optional Features:

Apart from regular model SWIFT electronic auto phase shifter, we also offer the shifters incorporated with EAPS-SL and EAPS, deluxe to fulfill the exact requirements of our clients.

Models Offered:

SWIFT EAPS - SL

This model is specially designed for 3 phase users. Who possess single phase wiring & UPS users (up to 5 KVA single phase), For UPS users (if they possess a 3 phase supply) UPS is connected to any one of the phases. In case of that particular phase fails then UPS changes to the battery mode.

If UPS is connected through swift electronic auto phase shifter, when 1 or 2 phases fails swift gives continuous supply from the alive phase automatically, thus enhances the life of the battery.

SWIFT EAPS - Deluxe (DX)

This model is available with high or low voltage cut off and if there is a high low voltage in any of the phases (Deluxe) it shifts to the next healthier phase automatically which enables smooth functioning of the electrical gadgets. The operating voltage range is normally set between 160 Volts & 250 Volts.

Swift Electronic EB Gen Automatic Change Over

When EB supply fails, this system automatically changes to the Genset mode. When EB supply resumes it goes back to the EB mode & automatically switches off the Genset (single Phase). 3 phase Genset change overs can also be supplied against order.

SWIFT EAPS EB GEN

This model is the combination of automatic phase shifter & Genset change over.

SWIFT EAPS - DB / EAPS - DDB

Swift Electronic auto phase shifter is also available along with the combination of single door distribution board db & double door distribution boards (DDB). These models fulfill the clients' requirements of separate distribution boards.

Avail from us AEE's high quality APFC Panels, which come with a Micro-controller based Programmable Controller. This controller automatically switches the capacitor banks of suitable capacity in multiple stages by directly reading the reactive load (RKVA) which works on the principle of VAR sensing, tends to maintain the PF to 0.99 Lag. The capacitor banks can be selected in number of stages as 3/4/6/8/12/16 as per the load pattern.

Salient Features :

• Fully Automatic
  
• Programmable Micro Controller based Technology
  
• Selects Capacitor Banks through VAR Sensing Principle
  
• 3 C.V.T.'s to measure all the three phases
  
• Automatic scrolling of voltages and currents in three phases, KW, RKVA, KVA and PF through LCD display.
  
• LOW and HIGH voltage protection
  
• Maintains Optimum Power Factor up to 0.99 Lag
  

Benefits:

• Power Factor penalty is avoided
  
• Avail incentives by maintaining optimum Power Factor
  
• Optimize the capacity by reducing the maximum demand KVA
  
• Avoids excess demand charges
  
• Improvement in line voltage
  
• Reduced line current losses and cable overheat
  
• Enhanced life of electrical circuits
  
• Avail Depreciation
  
• Reduced consumption (KWH) charges
  
• Avoids overloading of Distribution Transformers
  
• Additional Service Connections in existing generation of power by reducing Energy Losses
  
• Reduced line losses Benefits SEB's and Nation
  
• Available from 10 KVAR model onwards.
  

Technical Specifications:

• Var Sensing Power Factor Controller
  

This controller works with VAR sensing Principle, Switching the Capacitors by directly measuring the exact RKVA demand, with 3 C.V.T's at the main incoming to sense all the 3 Phases, appropriate for Single Phase Loads, with a Scrolling LCD Display to show the following parameters:

1. Instantaneous Voltages, Currents in all the 3 Phases and instantaneous KW, RKVA, KVA & PF
2. No. Of Capacitor Banks ON or OFF, indicate Imbalance load, indicate change in phase sequence
3. Built-in protections like High/Low Voltage cut-off, Single Phasing Prevention.

• Capacitors:
  

SIEMENS -EPCOS/ DUCATI/L&T- MPP- Type (440 V / 50 Hz / Delta Connected)

• Capacity with No. of stages
  

Standard Models

• Minimum VAR Compensation
  

25 kvar & in steps of 25 kvar up to 200 kvar

• Contractors:
  

Contractors to Switch-in & Switch-out the Capacitor of ABB/ SIEMENS/ L & T make at 440 V / 230 V AC coil of twice the capacitor current rating

• Current Sensors(C.V.T's) of 3 Nos. for measuring the Current in all 3 Phases.
  
• MCB / MCCB-Incoming of ABB / SIEMENS / L&T Make to connect or disconnect the panel from power system.
  
• Proper Current Limiters to cater the in-rush current.
  
• Line Filters to protect system from line surges.
  
• A Powder Coated cabinet of 18 SWG / CRCA steel sheet to enclose all the above items of Floor Mountable type (subject to change without prior notice)
  
• Cable should be of HFFR (Halogen Free Fire Retardant) Grade for interconnecting the system.
  

We are one of the leading manufacturer and supplier of Automatic Changeover Cum Current Limiter under the brand name Swift. These Automatic Changeover Cum Current Limiter helps by providing back up during the power failure. These also helps to solve the problem of overload by switching off the main supply as soon as overload occurs and resuming it as soon as the overload problem sorted out.

These are supplied under three models:

• Single Phase
• 3 Phase EB - Single Phase Gen
• 3 Phase EB - 3 Phase Gen Models

Suitable Model may be chosen depending on the application and circuit wiring.

Standard Models:

SI.NO	MODEL	INPUT-Phase		OUTPUT-Phase		CAPACITY(in Amps)
		EB	GEN	EB	GEN	EB	GEN
1	ACCL 1-20	1	1	1	1	20	5
2	ACCL 2-09	3	1	3	1	9	5
3	ACCL 2-16	3	1	3	1	16	5
4	ACCL 2-25	3	1	3	1	25	5
5	ACCL 2-40	3	1	3	1	40	5
6	ACCL 3-09	3	3	3	3	9	9
7	ACCL 3-16	3	3	3	3	16	16
8	ACCL 3-25	3	3	3	3	25	25
9	ACCL 3-40	3	3	3	3	40	40
10	ACCL 3-50	3	3	3	3	50	50

Electronic Automatic Phase Sequence Corrector gives an output of 3 phase supply in right sequence and always maintains 120° between phases, even when the input sequence is interchanged. This makes all 3 phase equipment continues to run irrespective of change in input phase sequence.

Salient Features:

• Fully automatic
• No manual intervention
• Single phase prevention
• High/low voltage protection
• Voltage imbalance protection between phases
• Output in the right sequence (R,Y,B)

SI.NO	MODEL	Capacity (AC3)Amps
1	PSC-09	9
2	PSC-16	16
3	PSC-25	25
4	PSC-32	32
5	PSC-40	40
6	PSC-50	50
7	PSC-60	60

We are one of the leading manufacturer and exporter of electrical  Illuminator which finds their usage in wide application across electrical industry. These products are known for the following features:

• Compact in size
  
• Igniter is not requried
  
• Can be fitted in existing gear box
  
• High power factor without Capacitors
  
• Constant Illumination with wide range of voltage fluctuation
  
• Output short Circuit protection
  
• Can be ignited even at 160V
  
• Reduction of VA burden
  
• Reduction in cable losses
  
• Increase in efficiency of overall unit
  
• Very low maintenance
  
• Eliminates use and throw concept of chokes
  
• Can be fitted at the bottom of the pole
  

Benefits:

• Enhanced life period of lamps
  
• Wide voltage fluctuation which standing capacity
  
• Improvement in the line voltage
  
• Steady lux output
  
• High intensity of light
  
• Optional dimming at off peak hours
  
• Cut down of maintenance cost
  
• Low heat generation
  
• Helps to reduce global warming
  
• Depreciation and carbon credits can be availed
  
• Saves power upto 50%

Technical Data
Size of the unit Models Suitable for Operating voltage Input frequency Short circuit protection Heat dissipation Off-peak dimming	Can be fitted in existing gear box 70W, 150W, 250W, 400W Sodium and Metal halide lamps 160V to 280V 50Hz. Built-in Very less Available(Optional)