Satna, Madhya Pradesh
Year of Establishment: 2008
IndiaMART Member Since: 2011
+ Development Boards (4)
+ Robotic Chassis (3)
+ Major Minor Projects (9)
+ Robo-Kits (10)
+ Sensors (5)
+ Programmers (2)
+ Electronics Products (4)
+ Quad-Rotor (3)
+ Interface Boards (3)
+ UAV (3)
+ RFID Tags & Reader (2)
+ Wireless (1)
+ Microcontrollers (2)
IR Proximity Sensor
This is a simple ir led proximity sensor. It is mainly an obstacle sensor, but can also be used for simple colour detection(between black and white), line following robots, etc. operating voltage 3 to 7v range of 50 cm for white objects and 35 cm for black objects(varies with surrounding light conditions) a multi-turn preset for accurately adjusting the range and sensitivity. output can be switched between active high and low using jumpers. the sensor has 4 holes of 3mm diameter for easy mounting.
40 KHZ Ultrasonic Transmitter And Receiver
Use this ultrasonic transmitter and receiver pair to make object sensors, distance sensors and motion sensors. Can be used to build distance measuring sensor frequency: 40khz transmitter and receiver come in metal casing lead spacing: 0. 28" case dimensions: 0. 30" h x 0. 43" dia.
Colour Camera With USART Interface
This is a simple to use colour camera. Just send the command to capture an image and the camera takes the snapshot and the onboard circuit compresses the image and sends it out through a serial connection. It can take photos of resolutions upto 640x480 pixels! Note:this product is sold out and we have no units in immediate stock but it is available upon order.
PIR Motion Sensor
Use this passive infrared detector for motion sensing. It has a simple digital interface. It signals any motion it senses with a high signal at its output pin. Simple three pin interface - vcc, gnd and output works withing the input voltage range of 5v to 9v setting time of 60 seconds range of upto 6 m. comes with a wide angle lens and a compact sized board.
CNG/Alchohol/Carbon Mono-oxide Sensor Module
These are simple to use Sensor Modules which can sense the presence of Alcohol/CNG/LPG/CO in the air. The module uses our MQ-3 sensor. It simplifies interface to the odd pin spacing of the sensor and provides interface through standard 4 x 0.1" header pins. It provides an analog output corresponding to the concentration of the gas in the air and an easy to use digital output. The onboard potentiometer can be used to set the maximum gas concentration beyond which the digital output gets triggered. Just power the module with 5V, set the threshold and you can start getting the gas concentration of the air around the sensor! An onboard LED signals the presence of any gas. Perfect sensing alcohol concentration on your breath, just like s common breathalyzer.
Buyers Tool KitSend Buy Requirement
Suppliers Tool KitPost Products - FREE
Mobile Channel: Connect with us: