ADVANTAGE:

• Uniform high welding quality.
• No additional material such as flux or filter necessary high duty cycle.
• Elimination of operations such as drilling and riveting.
• The method has a higher depth of penetration compared to other stud welding processes.
• These machines are most commonly used in transformer manufacturing, ship building industry, structural steel industry, power plants, automobile industry etc.

	AR 5000	AR 8000
Stud welding range (Thread size)	M4 to M12	M8 to M16
Welding Current	800 A	1500 A
Welding Time	5 to 500 ms	10 to 950 ms
Power	413 V 3 Phase 50 Hz	415 V 3 Phase 50 Hz
Power Source	Transformer / Rectifier	Transformer / Rectifier
Welding Cable	3 Metre	3 Metre
Welding material	Mild steel, Stainless steel	Mild steel, Stainless steel
Welding Gun	GapGun	GapGun

• Pipe Welding
• Heater Pipe Welding
• Heater Pipe Welding
• Seat Hanger
• Shock Absorber, Struts, Monotube & Gas Spring
• Nut Welding
• Nickel Planted Aircraft Battery Plate
• Struts
• Hydraulic Cylinder Oil Port Welding
• Fabricated Impellers

ADVANTAGE:

• Uniform high welding quality.
• Applicable to different materials.
• No re-working necessary on the other side of the weld.
• No additional material necessary, such as flux, inert gas rings.
• Elimination of different operations such as drilling and riveting etc.

MODEL	CD 1000
Welding Range	M3 - M8 or 3 - 8 mm with stainless steel, aluminum & brass
Welding Method	Tip Ignition
Standard Pistol	Mechanic Positioning
Power Source	Capacitor Battery
Charging Capacity	66.000 UF
Charging Voltage	50 - 200 V infinitely variable
Welding Time	Up to 10 Studs / min depending on stud diameter
Power Supply	230 V - 50 Hz - 1
Welding Cable	3m highly flexible
Ground Cable	2 x 3m highly flexible
Dimensions	300 x 120 x 320 mm (width x height x depth)

• Large scale reduction in KVA demand.
• Welding of similar and dissimilar metals possible.
• No water-cooling required for electrodes.
• Installation and operating cost of the machine is less.
• Machine can run on Genset.
• Welding joint free of blackening and distortion.
• No effect of voltage fluctuation on weld quality.
• Welding of heat sensitive parts is possible.
• Minimum heating of components during welding.
• As there is no heating of electrodes and no water cooling is required, cost of manufacturing and maintenance of fixtures and electrodes is reduced considerably.
• All recommended electrode materials are suitable for these welders.
• Models available: 0.5 - 30 KVA