Street Light Poles

Swaged poles are manufactured from E.RW/Welded tubes of suitable lengths swaged & joined together. No circumferential joint shall be permitted In the individual tube lengths of poles. The longitudinal welds shall be staggered at each swaged joint. Swaging is done by Hydraulic Power Pack Unit A circumferential weld shall be deposit at the upper and of the joint at aslope of approximately 45⁰ poles are manufactured by us normally conform to As per IS 2713 (P-II)-1980 and special sires poles can also be manufactured by as per customer drawings or requirements

 

Earthing arrangement

If earthing arrangement is required, a bolt of 10 mm dia is welded on each pole at a height of 300 mm above the planting depth or can be provided as per customer's requirement

 

Quality control

We have arrangement for strict quality control right from the receipt of raw material upto the final stage. The outside diameter, thickness, length of sections and the length of the pole controlled to come within the required specification.

 

Advantage

Steel tubular Poles are the most efficient and economical source for carrying the overhead transmission and overhead distribution lines which no other source can take place. Owing to the circular cross section, the poles with stand torsinal stresses much better. Cylindrical surface offers minimum wind resistant and due to their elasticity, can take all sorts of shocks, cyclones. Thrust lines breakage etc. for better than any other type of poles Bring light weight permits easy handling, transportation, low depth erection and less maintenance cost which insured the greatest economy of steel tublar poles.

 

 

 

Swaged Poles

• Based on the assumption that steel weights 7.85g/cm3 * Before making a selection of pole It is necessary to assume a suitable factor of safety has to be applied on the breaking load or the crippling load of the pole as the case may be depending on the relevant electricity rules to obtain the working load.

• Value of working load of the poles with a factor of safety of 2 on crippling load and a Factor 2.5 on breaking load are both given in tables 1 &2 In Indian standard book The user will have to calculate the working load if different actors of safety other then those stated above are applied.

• Length the tolerance of the length of section shall be follows : On the length of section + 40mm On the overall length + 10 mm.

• The mean weight for bulk supplied shall not be more than 5% below the calculated value the weight of any single pole shall not fall below the calculated weight more than 7.5%.

• Permissible tolerance on the tube thickness 10%.

Swan Neck Pole are widely used as street light poles for lighting on roads, gardens, these are specially made with supreme quality of steel with best designs and adjustable lengths. Swan neck poles are made of seamless or welded tubes of suitable lengths swan and joined together. These poles are also available as per the different specification such as sizes, shapes and designs. The features of Swan Neck Pole

• Stylish swan like neck on the capital
• Extremely light weight
• Easy installation
• Durable and strong

We are also offering Swan Neck Pole bent on both sides which provide lighting facility on both sides of road. Owning to this feature these are mostly used for lighting on roads, gardens and high ways. These Poles have been proved to be very economical with double neck features and durability. These poles are also made with high grade of steel and known for its light weight. With the detailed specification from the clients, we can also designs the poles and provide them in committed time period to them.