It is an epoxy based formulation specially designed for bonding old concrete and new concrete/ plaster providing monolithic surface. Normally cement slurry is used in such conditions, which does not perform to the satisfaction and shrinkage crack is developed at the junction of old concrete and new concrete. This crack becomes the source of leakage. Dripseal-ba-34 has excellent bonding with almost all types of construction material, so hacking or chipping of old surface is not desired. Dripseal-ba-34 is available in liquid form and two pack system. Both parts are to be mixed and applied on old concrete. Fresh concrete/plaster is laid when the coating is little touch dry.
Dripseal-gc-35 is an epoxy based formulation, specially designed to meet the requirement of grouting cracks, where cement slurry does not serve the purpose. Its low viscosity enables it to penetrate deep even in fine cracks. It has no shrinkage and it has high bonding strength. It is available in two packs, which are to be mixed together just before application. Mix only that much quantity which may be used within 30 to 50 minutes. Horizontal cracks can be sealed by gravitation system or with pressure grouting, whereas vertical and overhead cracks are to be sealed by pressure grouting. In addition, it can also be used for various waterproofing purpose, such as basement, lift pit, water storage tank etc, due to its low viscosity it is very easy to apply with brush, so it can be applied as base coat or primer coat before application of various other dripseal coatings.
Shop Number- 32, Opposite Air Force Club, Sector- 31-C,