MS Bolts
| Quantity Per Pack | 100 |
| Brand | POP.BHARATH |
Interlock
Interlock rivets are the most common type of 'structural' or high strength rivet. They are specifically designed to provide superior pull out and shear strength. This additional strength is achieved by using a specially designed mandrel (orange) that is pulled into the rivet (green), creating a double thick wall as shown below.
| Before Installation | Installed |
A side effect of the extremely tight fit of the mandrel inside the interlock rivet is that interlock rivets are water tight.
Because they are designed for maximum holding power, interlock rivets are found only in large sizes. For this reason smaller hand riveters do not have the strength to install them.
View Complete Details
| Material | Mild Steel |
| Brand | AMEEJI, |
| Size | M 3 TO M 8 |
| Quantity Per Pack | 250 |
SME standards specify a variety of "Machine Screws"[9] in diameters ranging up to 0.75 in (19.05 mm). These fasteners are often used with nuts but also often driven into tapped holes (without nuts). They might be considered a screw or a bolt based on theMachinery''s Handbook distinction. In practice, they tend to be mostly available in smaller sizes and the smaller sizes are referred to as screws or less ambiguously as machine screws,
View Complete Details
| Size | ALL |
| Quantity Per Pack | 10 |
| Brand | ALL |
We supply steel hex bars, rounds bars and square bars in superior surface finish and straightness, tolerance for pump shaft quality. Hex bars can be packed especially to avoid bending and scratches. Application : Ball Valves, Needle Valves, Filter Valves, Connectors, Couplings, Plugs, Hose Ends, Manifolds, Nuts, Bolts.
View Complete Details
| Brand | ptta |
| Size | all |
| Quantity Per Pack | 10 |
Drop-In anchors are female concrete anchors designed for anchoring into concrete. Drop the anchor into the predrilled hole in the concrete. Using a setting tool expands the anchor within the hole in the concrete.
View Complete Details
| Size | ALL |
| Quantity Per Pack | 1000 |
| Brand | PATTA / PTTA / HP |
| Multi-grip These rivets are specifically designed for situations where you don''t know how long a rivet you might need (the grip). They are more expensive than standard rivets, but when a long length is used on thin material they compact, leaving less material hanging off the back as shown below.
|
View Complete Details
- Developed and Managed by IndiaMART InterMESH Limited