Chennai Technology

A regular cell phone repeater consists of: (full kit)

• 1 -Outdoor antenna log periodic antenna(or wall mounted, yagi antenna)
• 2 - Indoor Omni ceiling antenna( panel antenna) 
• 3 – Power adapter 
• 5 - User manual
• 6 - Cell phone repeater
• 7. 10 meters outdoor cable and 1 meter indoor cable

Cell phone becomes especially helpful when people get into critical situations. In case of emergency a timely call can save somebody's life.

Unfortunately, there are still some places where they can find themselves "out of coverage" ,no signal at all... Usually those places are either too far from the cell phone base station or located inside underground constructions, for example:

• Parking lots, tunnels
• Big stores, office buildings
• Cars, boats etc.
• House in remote areas

•The outside antenna catches low signal from operator servicer's base station and delivers it to cell phone repeater through the connection cable (coax).

•After the signal is accepted by the mobile repeater, this device amplifies it.

•Then this amplified signal goes through the connection cable (coax) to the inside antenna.

•And after that, the amplified signal transmits to your cell phone.

• Finally, your cell phone will get good signal, never on and off

A regular cell phone repeater consists of: (full kit)

• 1 -Outdoor antenna log periodic antenna(or wall mounted, yagi antenna)
• 2 - Indoor Omni ceiling antenna( panel antenna)
• 3 – Power adapter
• 5 - User manual
• 6 - Cell phone repeater
• 7- 10 meters outdoor cable and 1 meter indoor cable

1*  GSM+WCDMA dual band repeater

1* AC power cord

1* Outdoor Antenna

1* Indoor Antenna with 2m cable

1* 10 meter Cable

How should you install repeater (very easy and simple):

Step 1: Use your mobile phone to test signal strength outside house or on roof, -70dbm is the basic requirement (full bar).

 Step 2 Install outdoor antenna in that location and keep adjusting, point it to signal tower station, try to get best signal.

 Step3: Run outdoor coaxial cable into building in a convenient location to connect with signal repeater.

 step 4: Mount your indoor antenna with signal repeater

step5:  Power up signal repeater device to check the signal inside, moving outdoor antenna until you get satisfied signal.

 Note: Connect outdoor (BTS) port with outdoor antenna, connect indoor ANT(MS) port with indoor antenna, outdoor antenna is mounted at a higher position. Both antennas should be 10 meters far away from each other at least.

Indoor and outdoor antenna must be separated by wall.

Cell phone becomes especially helpful when people get into critical situations. In case of emergency a timely call can save somebody’s life.

Unfortunately, there are still some places where they can find themselves “out of coverage” ,   no signal at all... Usually those places are either too far from the cell phone base station or located inside underground constructions, for example:

• Parking lots, tunnels
• Big stores, office buildings
• Cars, boats etc.
• House in remote areas

A regular cell phone repeater consists of: (full kit)

• 1 -Outdoor antenna log periodic antenna(or wall mounted, yagi antenna)
• 2 - Indoor Omni ceiling antenna( or panel antenna)
• 3 – Power adapter
• 5 - User manual
• 6 - Cell phone repeater
• 7-  10 meters outdoor cable and 1 meter indoor cable

Cell phone becomes especially helpful when people get into critical situations. In case of emergency a timely call can save somebody’s life.

Unfortunately, there are still some places where they can find themselves “out of coverage” ,   no signal at all... Usually those places are either too far from the cell phone base station or located inside underground constructions, for example:

• Parking lots, tunnels
• Big stores, office buildings
• Cars, boats etc.
• House in remote areas

•The outside antenna catches low signal from operator servicer’s base station and delivers it to cell phone repeater through the connection cable (coax).

•After the signal is accepted by the mobile repeater, this device amplifies it.

•Then this amplified signal goes through the connection cable (coax) to the inside antenna.

•And after that, the amplified signal transmits to your cell phone.

• Finally, your cell phone will get good signal, never on and off.

A regular cell phone repeater consists of: (full kit)

• 1 -Outdoor antenna log periodic antenna(or wall mounted, yagi antenna)
• 2 - Indoor Omni ceiling antenna( or panel antenna)
• 3 – Power adapter
• 5 - User manual
• 6 - Cell phone repeater
• 7-  10 meters outdoor cable and 1 meter indoor cable

Cell phone becomes especially helpful when people get into critical situations. In case of emergency a timely call can save somebody’s life.

Unfortunately, there are still some places where they can find themselves “out of coverage” ,no signal at all... Usually those places are either too far from the cell phone base station or located inside underground constructions, for example:

• · Parking lots, tunnels
• · Big stores, office buildings
• · Cars, boats etc.
• · House in remote areas

• •The outside antenna catches low signal from operator servicer’s base station and delivers it to cell phone repeater through the connection cable (coax).

   

  •After the signal is accepted by the mobile repeater, this device amplifies it.

   

  •Then this amplified signal goes through the connection cable (coax) to the inside antenna.

   

  •And after that, the amplified signal transmits to your cell phone.

   

  • Finally, your cell phone will get good signal, never on and off

   

  A regular cell phone repeater consists of: (full kit)

  • · 1 - Outdoor antenna like YAGI antenna or panel antenna
  • · 2 - Indoor Omni ceiling antenna 
  • · 3 – Power adapter 
  • · 5 - User manual
  • · 6 - Cell phone repeater
  • · 7. 10 meters outdoor cable and 1 meter indoor cable 

 Hot sales factory 2100  booster network 3G mobile signal repeater

1.High quality,with CE,ISO,RoHs certification

A regular cell phone repeater consists of: (full kit)

• 1 -Outdoor antenna log periodic antenna(or wall mounted, yagi antenna)
• 2 - Indoor Omni ceiling antenna( panel antenna) 
• 3 – Power adapter 
• 5 - User manual
• 6 - Cell phone repeater
• 7. 10 meters outdoor cable and 1 meter indoor cable

1*  GSM+WCDMA dual band repeater

1* AC power cord

1* Outdoor Antenna

1* Indoor Antenna with 2m cable

1* 10 meter Cable

How should you install repeater (very easy and simple):

Step 1: Use your mobile phone to test signal strength outside house or on roof, -70dbm is the basic requirement (full bar).

 Step 2 Install outdoor antenna in that location and keep adjusting, point it to signal tower station, try to get best signal.

 Step3: Run outdoor coaxial cable into building in a convenient location to connect with signal repeater.

 step 4: Mount your indoor antenna with signal repeater

step5:  Power up signal repeater device to check the signal inside, moving outdoor antenna until you get satisfied signal.

 Note: Connect outdoor (BTS) port with outdoor antenna, connect indoor ANT(MS) port with indoor antenna, outdoor antenna is mounted at a higher position. Both antennas should be 10 meters far away from each other at least.

Indoor and outdoor antenna must be separated by wall.

23dbm mobile signal repeater dual band GSM WCDMA booster 2g 3g cell phone signal booster

1:Cover about 100-250sqm without block
2:Output Power:20dbm
3.65dBi gain

4.Certification:CE,ROHS

Cell phone becomes especially helpful when people get into critical situations. In case of emergency a timely call can save somebody’s life.

Unfortunately, there are still some places where they can find themselves “out of coverage” , no signal at all... Usually those places are either too far from the cell phone base station or located inside underground constructions, for example:

• Parking lots, tunnels
• Big stores, office buildings
• Cars, boats etc.
• House in remote areas

•The outside antenna catches low signal from operator servicer’s base station and delivers it to cell phone repeater through the connection cable (coax).

•After the signal is accepted by the mobile repeater, this device amplifies it.

•Then this amplified signal goes through the connection cable (coax) to the inside antenna.

•And after that, the amplified signal transmits to your cell phone.

• Finally, your cell phone will get good signal, never on and off.

A regular cell phone repeater consists of: (full kit)

• 1 -Outdoor antenna log periodic antenna(or wall mounted, yagi antenna)
• 2 - Indoor Omni ceiling antenna( or panel antenna)
• 3 – Power adapter
• 5 - User manual
• 6 - Cell phone repeater
• 7- 10 meters outdoor cable and 1 meter indoor cable