Cygnet Surface Coatings

Pune, Maharashtra

| GST  27AFTPJ6894H1ZL

is a member of IndiaMART

| Verified Supplier

View Mobile Number84% Response Rate

Polyurethane Paints

Providing you the best range of Cythane 906 Polyurethane Paint with effective & timely delivery.

  • Cythane 906 Polyurethane Paint
  • Cythane 906 Polyurethane Paint
  • Cythane 906 Polyurethane Paint
  • Cythane 906 Polyurethane Paint
Cythane 906 Polyurethane Paint
Interested in this product?
Get Best Quote
ColorAll RAL Colours
Solids Content55+- 3 %
Viscosity80 +/- 5 seconds at 30 Degree C (Fordcup B4)
Flash Point15 Degree C (Closed Cup)
Temperature ResistanceUp to 120 Degree C Dry Temperature
Application MethodsAirless or Conventional spray. Brush may be used for smaller areas
Pot Life8 hours (Reduced at higher temperature) at 23 Degree C

Cythane906 Topcoat is a two component aliphatic urethane with exceptional resistance to chemicals and ultraviolet light. Each component is factory packaged in ratio & ready for on site mixing. The resin component is coloured differently and hardener is clear to give a visual on complete mixing prior to use.
Provides an easy to clean and attractive protective coating for cementitious or metallic substrates. Suitable for industrial structural steel, tanks, piping and concrete floors and walls in power, water water treatment, pulp and paper, chemical, petrochemical, food and beverage plants and pharmaceutical production areas where only foot traffic and light vehicles are expected. This hard, non-chalking coating cures through chemical reaction, and is not dependent on atmospheric conditions. 
Hard, durable, matt finish
Easy to clean
Attractive range of colours
Good chemical resistance
High abrasion resistance
No chalking, UV light resistance 
Condition during application:
The temperature of the substrate should be maximum 10 Degree C and minimum 3 Degree C above the dew point of the air, temperature and relative humidity measured in the vicinity of the substrate. The drying surface is sensitive to moisture condensation and relative humidity during application and until hard dry condition is achieved should be less than 85 %. Good ventilation is necessary when the paint is used in confined spaces. With forced ventilation, avoid heated air at first as this may cause surface drying and solvent entrapment. Cythane906Topcoat should not be exposed to mechanical wear before fully cured.
The product must be stored in accordance with standard reulations. Preferred storage conditions are to keep the containers in a dry space provided with adequate ventilation. The containers should be sealed tightly. 
Health and Safety:
Please observe the precautionary notices displayed on the container.
Spray under wellventilated conditions.
Do not breath or inhale mist.
Avoild skin contact.
Spillage on the skin should immediately be removed with suitable cleaner, soap and water. 
Eyes should be well flushed with water and medical attention sought immediately.  

View Complete Details

Yes, I am interested!

Get in touch with us

Reach Us

Cygnet Surface CoatingsSurvey No. 44/9, Narhe, Next To Darshana Properties, Pune-411041, Maharashtra, India

Nilesh Joshi (Proprietor)

View Mobile Number84% Call Response Rate

Send SMS
Send Email
Send Payment
Leave a Message, we will call you back!
Send your enquiry to this supplier
terms privacy policy

We Accept Online Payments

All Rights Reserved (Terms of Use)