J. K. Overseas

We also offer high quality PTFE rods, bushes, PTFE tubes and ptfe sheets for different requirements of our clients. Superior in quality, these products are known for their durability and performance and are available with following specifications.

Bushes Specifications:

• O. D : 32-150mm (standard)
• I. D : 12. 5-127mm (standard)
• Length : 100mm (standard) upto 300mm in special cases
• We can also supply larger sizes on request rods
  
  Specifications:
• Dia : 3-250 (standard)
• Length : 300-900mm (standard)
  
  PTFE sheets specifications:
• Sizes available : 300 x 300mm to 900 x 900mm
• Thickness : 3-25mm thickness sheets available on request ptfe-filler also PTFE thin sheets
  
  Specifications:
• Width : 300-600mm
• Thickness : 0. 1-3. 0mm
• Thin sheets are available in roll form or cut to length form. available in roll form or length cut to request.
  
  Fillers Specifications: glass/carbon/graphite/bronze+mos2.

We manufacture and supply superior quality PTFE moulded products, PTFE machined products and PTFE soft unsintered products for various applications. The importance of PTFE machined & moulded products becomes more important as it is often more efficient to use moulded semi-finished products to avoid excessive machining of relatively expensive materials and for reducing the machining labour and time. The tooling costs are normally very low. We offer these PTFE products in two forms viz milled form and slit form. Milled type envelope is a better method as it is made to fit the insert and presents a flat face to tee flange. The Slit type is perfectly adequate for applications where cost is considered a major factor. The envelop in this type does not present a full face to the flange. Solid Gaskets can also be made in different types of shapes and sizes on request.

Specifications:

• Size: 12mm onwards
• Thickness of flap is 0.5mm
• Can also be supplied in oval shapes and larger sizes on request. These gaskets are widely used for applications in chemical plants, glass/glass lined equipment due to their high temperature, corrosion and durability. Envelope Gaskets are produced in two forms viz. milled and slit forms.