Komal Tex Fab Private Limited

1. 15 to 36VDC Supply Voltage 
2. H-Bridge, 2 Phase Bi-polar Micro-step motor driver 
3. Suitable for 2-phase, 4, 6 and 8 leads step motors, with Nema size 16 to 23 
4. Output current selectable from 0.21 ~ 1.5A peak 
5. Compact credit card size package 
6. Optically isolated single ended TTL inputs for Pulse, Direction and Enable signal inputs 
7. Selectable resolutions up to 12800 steps 
8. Over Voltage, Coil to Coil and Coil to Ground short circuit protection.

1. 15 to 36VDC Supply Voltage 
2. H-Bridge, 2 Phase Bi-polar Micro-step motor driver 
3. Suitable for 2-phase, 4, 6 and 8 leads step motors, with Nema size 16 to 23 
4. Output current selectable from 0.21 ~ 1.5A peak 
5. Compact credit card size package 
6. Optically isolated single ended TTL inputs for Pulse, Direction and Enable signal inputs 
7. Selectable resolutions up to 12800 steps 
8. Over Voltage, Coil to Coil and Coil to Ground short circuit protection. 

1.20 to 50VDC supply Voitage 
2.H-Bridge ,2 Phase Bi-polar Micro-stepping Drive 
3.Suitable for 2-phase ,4,6and8 leads step motors.with Nema size16 to 24 4.Output current selectable from 1.0~4.2A peak 
5.Current reduction by 50% automatically,when motor standstill mode is enabled 
6.Maximum steps for 25000 steps 
7.Over Voltage ,Coil to Coil and Coil to Ground short dircuit protection 

1.20 to 50VDC supply Voitage 
2.H-Bridge ,2 Phase Bi-polar Micro-stepping Drive 
3.Suitable for 2-phase ,4,6and8 leads step motors.with Nema size16 to 24 4.Output current selectable from 1.0~4.2A peak 
5.Current reduction by 50% automatically,when motor standstill mode is enabled 
6.Maximum steps for 25000 steps 
7.Over Voltage ,Coil to Coil and Coil to Ground short dircuit protection 

2M982 is a cost effective, high performance bi-polar two phase micro-step motor driver applying pure-sinusoidal current control technique. It is best suited for the applications that desired extreme low noise and heat. It operates well in an environment, where electricity supply experience instability and fluctuation. The general pseudo-sinusoidal current control technology adopted by majority of the drive produced distorted sine wave, and current ripple, resulting in vibration, noise and motor heating. This results in motor degrading over time, reducing in motor performance and shortens the usage life. With an automatic optimization speed control technique, the PowerStep series drive output is very stable, with almost zero vibration and noise, performing close to a servo system, allowing the motor to operate smoothly. That helps to fulfill a design requirement of low noise, low heat and high performance