Kwick Fix Solutions

A. What is SBS SELF ADHESIVE MEMBRANE (ALUMINIUM TOP) 

SBS Waterproof Material Self Adhesive Aluminium Membrane  is produced with SBS elastomer and bitumen as raw materials, using polyethylene film.

Aluminium foil coated on the upward or no file(both side self-adhesive) while self-adhesive protection layer on the downward 

surface.It has a widely prospect new contruction waterproof materials. Good self-adhesion, no leaking,cold flexibility,especially

in self-adhesion. That is unque product in waterproof and application.

B. Why Kwick Fix Solutions is Best Option for SBS SELF ADHESIVE MEMBRANE (ALUMINIUM TOP) ?

1. KWICK FIX SOLUTIONS purchases material from the core company / factory or its authorised channel only. Hence, KWICK FIX SOLUTIONS sells only orginal & genuine products.

2. KWICK FIX SOLUTIONS has ready stock and fresh material available.

3. KWICK FIX SOLUTIONS is located in the hub of mumbai transport area. Hence, deliveries are prompt. 

4. KWICK FIX SOLUTIONS is a trusted brand and has a reputation of over 120 years in the market. The company is an extension of a 120 year old firm.

• It is used as waterproofing /dam proofing membrane for protection of various substrates in wide range of applications.
• Medium to large roof slabs ( domestic, commercial and industrial) Basements and raft slabs
• Underground car parks etc.
• Bridges & Underpass

• Substrate Quality Concrete, mortar surfaces must be clean, free from grease, oil, and loosely adhering particles. Steel and iron surfaces must be free from scale, rust, grease and oil.

• Application procedure may vary slightly depending upon site conditions. However given below are general guidelines. Apply bituminous primer to a clean, smooth and dry surface by brush, roller or spray. Unroll and align and re roll correctly before torching. Overlaps should be minimum 100mm.Use gas burner to heat the substrate and thermo fusible film on the underside on lower face of membrane. When the thermo- fusible film melts after torching, the membrane is ready to stick. Roll forward and press firmly against the substrate to bond. Heat both the overlaps and use the round tipped trowel heating the same to smoothen and press into seam. All angles and abutments should be sealed with extra care to ensure full bondage. The edges should be sealed well into the grooves.

• All technical data stated in this Product Data Sheet are based on laboratory tests. Actual measured data may vary due to circumstances beyond our control.

• For information and advice on the safe handling, storage and disposal of chemical products, users shall refer to the most recent Material Safety Data Sheet containing physical, ecological, toxicological and other safety-related data.

• Sunken Areas
• Basement & Foundations
• Wet Areas(Bathrooms/Kitchens)
• Small SWimming Pools
• Slopped Concrete Rooftops
• Cement Fiber Board Panels/Dry Walls
• Small & Medium Terraces