Meatech Solutions

Onset’s research-grade data-logging weather stations are known for performing reliably in the field year after year. These systems offer rugged, weatherproof protection from the elements, and are available in both USB and web-based versions. HOBO weather stations can be configured with any combination of plug-and-play Smart Sensors for measuring air temperature, relative humidity, dew point, rainfall, soil moisture, solar radiation, wind speed and direction, barometric pressure, and more.

The eddy-covariance (EC) technique is widely used to quantify the exchange of heat, carbon dioxide, water vapor, and other trace gases between Earth’s surface and the atmosphere. These data provide the information required to analyze carbon storage properties of various ecosystems, create accurate gas exchange budgets, and compare emissions characteristics between various land use such as agricultural lands, forestlands, sagebrush steppe, or urban plots and landfills.

The EC technique requires the measurement of vertical wind speed and a scalar of interest, such as CO2 or H2O. Ideally these measurements would have low noise and high frequency response, and they would be colocated and synchronized. Wind velocity is typically measured with a three-dimensional ultrasonic anemometer

We offer is a turn-key, closed-path eddy-covariance (EC) flux system for long-term monitoring of atmosphere-biosphere exchanges of carbon dioxide, water vapor, heat, and momentum. A complete system consists of a closed-path gas analyzer (EC155), sonic anemometer (CSAT3A), datalogger (CR3000), and sample pump.

Dataloggers, which may also be referred to as Measurement and Control Units (Systems) or Microloggers, are the heart of a data acquisition system. They measure sensors at a specific scan rate, process data, store the data, and initiate telecommunication. Our dataloggers also have control capabilities allowing them to respond to specific site conditions by opening flood gates, turning fans off/on, etc.

We offer wide range of sensors which are generally designed for long-term installation under adverse environmental conditions. Sensors used in industrial applications such as strain gages, accelerometers, hydraulic pressure transducers, are also available. We have a long chain of sensors for example: Air  Temperature Sensors, Air Temperature & Relative Humidity, Barometric Pressure Sensors, Basic Weather Conductivity Sensors,Digital Camera, Dissolved Oxygen Sensors, Distance Sensors, Duff Moisture Sensors, Electric Field Sensors, ph, Dissolve oxygen, precipitation etc.

Ideal for applications that do not require wind direction measurements, these meters are compatible with all Campbell Scientific dataloggers (including the CR200(X) series). They are ideal for wind profile studies and  designed for continuous, long term, unattended operation in adverse conditions

They are compatible with the LLAC4 4-channel Low Level AC Conversion Module, which increases the number of anemometers one datalogger can measure. The Campbell Scientific version uses shielded bearings, which lowers the anemometer's starting threshold

ZephIR 300 wind lidar is used extensively through the pre-planning / scoping, planning, development, construction and operational phases of an onshore wind energy project in combination with short met masts and tall met masts and associated cup anemometers, roaming during site-prospecting, stand-alone in replacement of a met mast and as a fixed reference control mast.

With our extensive experience in the industry, we are able to support you with a range of Support Packages designed to make remote wind measurement and data collection both simple and user-friendly.