Every car should have one. This magnetic drain plug for your watercooled VW traps any particles of ferrous metal and prevents them from being recirculated in your oil system. M14x1.5 fits all VWs with 4, 5, or 6-cylinders. Not applicable for Schrick aluminum oil pan.
For all VW Golf 4, Jetta 4, New Beetle and Audi A4 & TT models using 1.8T engines. Designed to retain stock 86.4mm crank stroke and 144mm connecting rod length. Available in std. or larger bore sizes to increase displacement. Also available with low & high compression ratios depending on boost levels used. Piston weights range from 300-310 grams!
Prices include pistons, rings, wrist pins and clips.
Note: Oversize pistons require boring the cylinder block.
This is the same windage tray as used with our Aluminum Oil Pan listed below. Its unique rubber seal eliminates the need for the traditional fiber gasket. A windage tray's purpose is to reduce parasitic horsepower loss caused by engine oil being "spun" by the crankshaft counterweights. This tray can provide new-found power during aggressive driving! Fits all 4-cylinder models. Supplied with the required longer pan bolts. Not for VR6 engines.
Autotech manufactures SportTuned lightweight titanium retainers for the ultimate street or race valvetrain. Each SportTuned retainer is made from Certified 6AL/4V titanium and is designed as a direct replacement for stock. They will work with stock or our SportTuned springs. After machining, they are Tiodized®, a proprietary process for titanium similar to hard anodizing of aluminum alloy, to increase durability. At around 1/2 the weight of stock, SportTuned Ti Retainers reduce reciprocating mass, creating a faster-revving engine, reducing the risk of valve float as well. Autotech makes this once esoteric part affordable for street use.
The VW steel spark plug boots are designed to seal and increase contact between the spark plug and spark plug wire. With the increased seal and location of the boot, a special tool has been developed to access and remove the spark plug boot. The tool is also needed in snapping the spark plug boot on to the spark plug that is in a very confined area. This spark plug boot tool was designed in hardened stainless steel for long-term service. The "T" handle gives you plenty of pulling power to remove and replace the most difficult spark plug boot. Manufactured by Schley Products in the USA.
Petes Automotive Products Private Limited
The International Hotel, P B No. 3563 M.g. Road, The International Hotel,, M G Road,
Kochi-682035, Kerala, India