12 Module Switch Board With Remote : 8 Lights & 2 Fan Regula

• Power On Indication
• All Digital ON/OFF Buttons to Operate Manually
• Each Light point can Handle 300 Watts Load using Built-in Relay
• Fan speed Display with 7 Step Regulation
• Built-in ON and OFF Timer (1 to 9 Hours) for Fan Regulator 
• Built-in Memory to Keep the Lights/Fans in Previous state after Power resumption 
• Full Function Remote Control 
• Remote Operating Distance up to 40-60 ft  
• Reduce Your Electricity Bill by putting off lights and fan immediately with remote control when not needed
• It Also Supports Inverter.
• Remote operation prevents us from Risk of electric shock and Short Circuit.
• No Alteration Required to your existing wiring while installing our unit.
• Easy Installation

The Main Advantages of a Remote control system when compared with mechanical switching systems are: -

• System saves unnecessary wiring and switches cost of 2 way switching.
• Spark less and contact less switching increases switches life.
• Prevents children from risk of electric shock and short circuit.
• It is a boon for physically handicapped persons.
• Can be installed in all hospital rooms used for bed ridden patients.
• All bed rooms used by elderly and aged people 

This Remote Control System can be used in any:  

House, Office,Restaurants, Shops, Hospitals & Conference or Seminar Halls, Etc...

Specifications:-

• Operating Voltage 180-280 Volts AC
• Frequency 50 Hz
• Load Capacity each switch - 300 Watts
• InfraRed Based Remote Control
• Remote Control Working range 40-60 Feet
• Use one "CR 2032" battery for remote control

Fan Regulator Instructions

This  Digital fan Regulator comes with Remote control. You can increase or decrease fan speed in 7 Steps.

To  activate  ON Timer -  Press  TOP BUTTON  (up speed control)  Continuously until you see 0 (Zero)  with dot blinking. At this point press once again top button to select  number of hours (1-9) that the fan should be ON.

To  activate  OFF Timer -  Press  Lower BUTTON  (Low speed control)  Continuously until you see 0 (Zero)  with dot blinking. At this point press once again bottom arrow button to select  number of hours (1-9) that the fan should be OFF.