Acrylic Based Polymer Coating 4 L Dr Fixit Roof Seal Classic Waterproofing Chemical

DescriptionDr. Fixit Roofseal Top Coat is a single component, insulating elastomeric waterproof coating for roofs that willoffer a seal against water and heat, waterproofing and insulating in easy steps. This monolithic waterproofmembrane provides superior crack bridging and long lasting tough weather protective seal for exposed (new andold) roof surfaces. Dr. Fixit Roofseal Top Coat combines the benefits of waterproofing as well as heat reductionin a single product. No additional protective coating is required for roof subjected to foot traffic. Easy to apply bybrush/ roller.Typical Applications} Building Roofs / Terraces – Flat & Slope.} Over Existing cementitious waterproofing treatments like sound brick-bat coba, concrete screeds, etc.Features} Waterproofing – Tough durable elastic membrane with > 200% elongation} Good Adhesion – Bonds strongly to the substrate} Crack bridging – High flexibility of materials enables it to bridge hairline cracks} Tough and abrasion resistant – Suitable for light foot traffic} Economical – Cost effective and durable coating} Bright white – Heat Reflective and UV resistant top coat} Temperature reduction – Reduces surface temperature up to 10ºC** in the pick summer} Eco friendly – Low VOCPackaging1, 4, 10 & 20 litreMethod of Application1 SURFACE PREPARATION} Prepare the surface thoroughly by cleaning, washing and removing dust, dirt, oil, grease and loose particles.Well prepared substrate.} Existing roof systems to be visually inspected for conditions that may adversely affect adhesion of performanceof newly installed products.} Damaged or hollow portions, sharp edges, etc. must be cut and repaired with a polymer-modified mortar usingDr. Fixit Pidicrete URP.} Ensure that the roof slope of a minimum of 1 in 100 is already provided.} The surfaces shall ideally be in Surface Saturated Dry (SSD) before application of Dr. Fixit Roofseal Top Coat, Donot apply to wet or visibly damp surfaces.2 CRACKS AND JOINTS} It is recommended to fill fine crack up to 1 mm with Dr. Fixit Roofseal Top Coat directly by brush or roller aftercleaning the cracks.} All surface cracks up to 5 mm width should be filled up with Dr. Fixit Crack-X paste.} In existing old terraces with brickbat coba or screeds, the substrate must be checked for its soundnessDamaged or hollow portions, sharp edges, remove any weak surface layer etc up to slab level. Just before layingthe Polymer modified mortar screed, reinstate the surface with bond coat slurry mix with Dr. Fixit Pidicrete URPin the ratio of 1:1 (1 part URP : 1 part Cement) Note - care being taken that this does not dries before the mortar,screed is placed. Level the surface with Polymer modified mortar mixing with Dr. Fixit Pidicrete URP 10 to 15% byweight of cement in the CM ratio of 1:3.3 APPLICATION PROCEDURE FOR ROOF (REPAIR & NEW)} Stir well prior to application.} All joints/corners/drainage outlets and penetration points shall be treated prior to all application of Dr. FixitRoofseal Top Coat. All corners, gaps, joints, protrusions and outlets should be coated with an extra coatincorporating reinforcing fabric.} Dr. Fixit Roofseal Top Coat may be applied by roller, brush. Apply a coat of Dr. Fixit Roofseal Top Coat (dilutedwith water in the ratio 2:1) as Self Priming - 9 - 10 Sq.mtr / litre .} Allow coating to dry for 3-4 hours prior to applying first coat & second coat.} Apply two coats of Dr. Fixit Roofseal Top